@@ -128,6 +128,8 @@ struct macb_device {
unsigned long dummy_desc_dma;
const struct device *dev;
+ unsigned int duplex;
+ unsigned int speed;
unsigned short phy_addr;
struct mii_dev *bus;
#ifdef CONFIG_PHYLIB
@@ -178,6 +180,12 @@ static int gem_is_gigabit_capable(struct macb_device *macb)
return macb_is_gem(macb) && !cpu_is_sama5d2() && !cpu_is_sama5d4();
}
+/* Is the port a fixed link */
+static int macb_port_is_fixed_link(struct macb_device *macb)
+{
+ return macb->phy_addr > PHY_MAX_ADDR;
+}
+
static void macb_mdio_write(struct macb_device *macb, u8 phy_adr, u8 reg,
u16 value)
{
@@ -666,97 +674,110 @@ static int macb_phy_init(struct udevice *dev, const char *name)
int i;
arch_get_mdio_control(name);
- /* Auto-detect phy_addr */
- ret = macb_phy_find(macb, name);
- if (ret)
- return ret;
+ /* If port is not fixed -> setup PHY */
+ if (!macb_port_is_fixed_link(macb)) {
+ /* Auto-detect phy_addr */
+ ret = macb_phy_find(macb, name);
+ if (ret)
+ return ret;
- /* Check if the PHY is up to snuff... */
- phy_id = macb_mdio_read(macb, macb->phy_addr, MII_PHYSID1);
- if (phy_id == 0xffff) {
- printf("%s: No PHY present\n", name);
- return -ENODEV;
- }
+ /* Check if the PHY is up to snuff... */
+ phy_id = macb_mdio_read(macb, macb->phy_addr, MII_PHYSID1);
+ if (phy_id == 0xffff) {
+ printf("%s: No PHY present\n", name);
+ return -ENODEV;
+ }
#ifdef CONFIG_PHYLIB
- macb->phydev = phy_connect(macb->bus, macb->phy_addr, dev,
- macb->phy_interface);
- if (!macb->phydev) {
- printf("phy_connect failed\n");
- return -ENODEV;
- }
+ macb->phydev = phy_connect(macb->bus, macb->phy_addr, dev,
+ macb->phy_interface);
+ if (!macb->phydev) {
+ printf("phy_connect failed\n");
+ return -ENODEV;
+ }
- phy_config(macb->phydev);
+ phy_config(macb->phydev);
#endif
- status = macb_mdio_read(macb, macb->phy_addr, MII_BMSR);
- if (!(status & BMSR_LSTATUS)) {
- /* Try to re-negotiate if we don't have link already. */
- macb_phy_reset(macb, name);
-
- for (i = 0; i < MACB_AUTONEG_TIMEOUT / 100; i++) {
- status = macb_mdio_read(macb, macb->phy_addr, MII_BMSR);
- if (status & BMSR_LSTATUS) {
- /*
- * Delay a bit after the link is established,
- * so that the next xfer does not fail
- */
- mdelay(10);
- break;
+ status = macb_mdio_read(macb, macb->phy_addr, MII_BMSR);
+ if (!(status & BMSR_LSTATUS)) {
+ /* Try to re-negotiate if we don't have link already. */
+ macb_phy_reset(macb, name);
+
+ for (i = 0; i < MACB_AUTONEG_TIMEOUT / 100; i++) {
+ status = macb_mdio_read(macb, macb->phy_addr, MII_BMSR);
+ if (status & BMSR_LSTATUS) {
+ /*
+ * Delay a bit after the link is established,
+ * so that the next xfer does not fail
+ */
+ mdelay(10);
+ break;
+ }
+ udelay(100);
}
- udelay(100);
}
- }
- if (!(status & BMSR_LSTATUS)) {
- printf("%s: link down (status: 0x%04x)\n",
- name, status);
- return -ENETDOWN;
- }
+ if (!(status & BMSR_LSTATUS)) {
+ printf("%s: link down (status: 0x%04x)\n",
+ name, status);
+ return -ENETDOWN;
+ }
- /* First check for GMAC and that it is GiB capable */
- if (gem_is_gigabit_capable(macb)) {
- lpa = macb_mdio_read(macb, macb->phy_addr, MII_STAT1000);
+ /* First check for GMAC and that it is GiB capable */
+ if (gem_is_gigabit_capable(macb)) {
+ lpa = macb_mdio_read(macb, macb->phy_addr, MII_STAT1000);
- if (lpa & (LPA_1000FULL | LPA_1000HALF | LPA_1000XFULL |
- LPA_1000XHALF)) {
- duplex = ((lpa & (LPA_1000FULL | LPA_1000XFULL)) ?
- 1 : 0);
+ if (lpa & (LPA_1000FULL | LPA_1000HALF | LPA_1000XFULL |
+ LPA_1000XHALF)) {
+ duplex = ((lpa & (LPA_1000FULL | LPA_1000XFULL)) ?
+ 1 : 0);
- printf("%s: link up, 1000Mbps %s-duplex (lpa: 0x%04x)\n",
- name,
- duplex ? "full" : "half",
- lpa);
+ printf("%s: link up, 1000Mbps %s-duplex (lpa: 0x%04x)\n",
+ name,
+ duplex ? "full" : "half",
+ lpa);
- ncfgr = macb_readl(macb, NCFGR);
- ncfgr &= ~(MACB_BIT(SPD) | MACB_BIT(FD));
- ncfgr |= GEM_BIT(GBE);
+ ncfgr = macb_readl(macb, NCFGR);
+ ncfgr &= ~(MACB_BIT(SPD) | MACB_BIT(FD));
+ ncfgr |= GEM_BIT(GBE);
- if (duplex)
- ncfgr |= MACB_BIT(FD);
+ if (duplex)
+ ncfgr |= MACB_BIT(FD);
- macb_writel(macb, NCFGR, ncfgr);
+ macb_writel(macb, NCFGR, ncfgr);
- ret = macb_linkspd_cb(dev, _1000BASET);
- if (ret)
- return ret;
+ ret = macb_linkspd_cb(dev, _1000BASET);
+ if (ret)
+ return ret;
- return 0;
+ return 0;
+ }
}
- }
- /* fall back for EMAC checking */
- adv = macb_mdio_read(macb, macb->phy_addr, MII_ADVERTISE);
- lpa = macb_mdio_read(macb, macb->phy_addr, MII_LPA);
- media = mii_nway_result(lpa & adv);
- speed = (media & (ADVERTISE_100FULL | ADVERTISE_100HALF)
- ? 1 : 0);
- duplex = (media & ADVERTISE_FULL) ? 1 : 0;
- printf("%s: link up, %sMbps %s-duplex (lpa: 0x%04x)\n",
- name,
- speed ? "100" : "10",
- duplex ? "full" : "half",
- lpa);
+ /* fall back for EMAC checking */
+ adv = macb_mdio_read(macb, macb->phy_addr, MII_ADVERTISE);
+ lpa = macb_mdio_read(macb, macb->phy_addr, MII_LPA);
+ media = mii_nway_result(lpa & adv);
+ speed = (media & (ADVERTISE_100FULL | ADVERTISE_100HALF)
+ ? 1 : 0);
+ duplex = (media & ADVERTISE_FULL) ? 1 : 0;
+ printf("%s: link up, %sMbps %s-duplex (lpa: 0x%04x)\n",
+ name,
+ speed ? "100" : "10",
+ duplex ? "full" : "half",
+ lpa);
+ }
+ else {
+ /* if macb port is a fixed link */
+ /* TODO : manage gigabit capable processors */
+ speed = macb->speed;
+ duplex = macb->duplex;
+ printf("%s: link up, %sMbps %s-duplex\n",
+ name,
+ speed ? "100" : "10",
+ duplex ? "full" : "half");
+ }
ncfgr = macb_readl(macb, NCFGR);
ncfgr &= ~(MACB_BIT(SPD) | MACB_BIT(FD) | GEM_BIT(GBE));
@@ -1276,6 +1297,30 @@ int __weak macb_late_eth_of_to_plat(struct udevice *dev)
static int macb_eth_of_to_plat(struct udevice *dev)
{
struct eth_pdata *pdata = dev_get_plat(dev);
+ struct macb_device *macb = dev_get_priv(dev);
+ void *blob = (void *)gd->fdt_blob;
+ int node = dev_of_offset(dev);
+ int fl_node, speed_fdt;
+
+ /* fetch 'fixed-link' property */
+ fl_node = fdt_subnode_offset(blob, node, "fixed-link");
+ if (fl_node >= 0) {
+ /* set phy_addr to invalid value for fixed link */
+ macb->phy_addr = PHY_MAX_ADDR + 1;
+ macb->duplex = fdtdec_get_bool(blob, fl_node, "full-duplex");
+ speed_fdt = fdtdec_get_int(blob, fl_node, "speed", 0);
+ if (speed_fdt == 100) {
+ macb->speed = 1;
+ }
+ else if (speed_fdt == 10) {
+ macb->speed = 0;
+ }
+ else {
+ printf("%s: The given speed %d of ethernet in the DT is not supported\n",
+ __func__, speed_fdt);
+ return -EINVAL;
+ }
+ }
pdata->iobase = (uintptr_t)dev_remap_addr(dev);
if (!pdata->iobase)