@@ -313,7 +313,7 @@ ulong board_spl_fit_size_align(ulong size)
return size;
}
-void board_spl_fit_post_load(ulong load_addr, size_t length)
+int board_spl_fit_post_load(ulong load_addr, size_t length)
{
u32 offset = length - CONFIG_CSF_SIZE;
@@ -321,8 +321,10 @@ void board_spl_fit_post_load(ulong load_addr, size_t length)
offset + IVT_SIZE + CSF_PAD_SIZE,
offset)) {
puts("spl: ERROR: image authentication unsuccessful\n");
- hang();
+ return -1;
}
+
+ return 0;
}
#endif
@@ -26,8 +26,9 @@ DECLARE_GLOBAL_DATA_PTR;
#define CONFIG_SYS_BOOTM_LEN (64 << 20)
#endif
-__weak void board_spl_fit_post_load(ulong load_addr, size_t length)
+__weak int board_spl_fit_post_load(ulong load_addr, size_t length)
{
+ return 0;
}
__weak ulong board_spl_fit_size_align(ulong size)
@@ -677,11 +678,12 @@ int spl_load_simple_fit(struct spl_image_info *spl_image,
if (spl_image->entry_point == FDT_ERROR || spl_image->entry_point == 0)
spl_image->entry_point = spl_image->load_addr;
- spl_image->flags |= SPL_FIT_FOUND;
-
#ifdef CONFIG_IMX_HAB
- board_spl_fit_post_load((ulong)fit, size);
+ ret = board_spl_fit_post_load((ulong)fit, size);
+ if (ret)
+ return ret;
#endif
+ spl_image->flags |= SPL_FIT_FOUND;
return 0;
}
@@ -564,7 +564,7 @@ int board_return_to_bootrom(struct spl_image_info *spl_image,
* board_spl_fit_post_load - allow process images after loading finished
*
*/
-void board_spl_fit_post_load(ulong load_addr, size_t length);
+int board_spl_fit_post_load(ulong load_addr, size_t length);
/**
* board_spl_fit_size_align - specific size align before processing payload
On i.MX platforms board_spl_fit_post_load() can check the loaded SPL image for authenticity using its HAB engine. U-Boot's SPL mechanism allows booting images from other sources as well, but in the current setup the SPL would just hang if it encounters an image that does not pass scrutiny. Allowing the function to return an error, allows the SPL to try booting from another source as a fallback instead of ending up as a brick. Signed-off-by: Patrick Wildt <patrick@blueri.se> --- Changes in v2: - set SPL_FIT_FOUND only after successful post load arch/arm/mach-imx/spl.c | 6 ++++-- common/spl/spl_fit.c | 10 ++++++---- include/spl.h | 2 +- 3 files changed, 11 insertions(+), 7 deletions(-)