[i2c-tools,1/2] tools: i2ctransfer: consequently document -a

The text describing the address to be used did not reflect the recent
change where some of the functionality of '-f' has been seperated into
'-a'.

Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
---
 CHANGES             | 1 +
 tools/i2ctransfer.8 | 8 +++++---
 2 files changed, 6 insertions(+), 3 deletions(-)

Hi Wolfram,

On Mon, 11 Mar 2019 23:33:34 +0100, Wolfram Sang wrote:
> The text describing the address to be used did not reflect the recent
> change where some of the functionality of '-f' has been seperated into
> '-a'.
> 
> Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
> ---
>  CHANGES             | 1 +
>  tools/i2ctransfer.8 | 8 +++++---
>  2 files changed, 6 insertions(+), 3 deletions(-)
> 
> diff --git a/CHANGES b/CHANGES
> index e2ea015..e9d46b5 100644
> --- a/CHANGES
> +++ b/CHANGES
> @@ -5,6 +5,7 @@ master
>    tools: Consistently use snprintf instead of sprintf
>    decode-dimms: Print SPD revision for DDR3 too
>                  Move SDR-specific code
> +  i2ctransfer: Mention '-a' everywhere in the manpage

Not sure how "once" qualifies as "everywhere" ;-)

>  
>  4.1 (2018-11-30)
>    Makefile: Make STRIP, DESTDIR and PREFIX overridable
> diff --git a/tools/i2ctransfer.8 b/tools/i2ctransfer.8
> index 5d3cc27..1f8ed82 100644
> --- a/tools/i2ctransfer.8
> +++ b/tools/i2ctransfer.8
> @@ -96,10 +96,12 @@ It is parsed as an unsigned 16 bit integer, but note that the Linux Kernel appli
>  specifies the 7-bit address of the chip to be accessed for this message, and is an integer.
>  If omitted, reuse the previous address.
>  Normally, addresses outside the range of 0x03-0x77 and addresses with a kernel driver attached to them will be blocked.
> -With
> +This can be overridden with
> +.I -a
> +(all) or
>  .I -f
> -(force), all addresses can be used.
> -Be very careful when using that!
> +(force).
> +Be very careful when using these!
>  10-bit addresses are currently not supported at all.
>  
>  .PP

Looks good to me.

Reviewed-by: Jean Delvare <jdelvare@suse.de>

> > +  i2ctransfer: Mention '-a' everywhere in the manpage
> 
> Not sure how "once" qualifies as "everywhere" ;-)

Yes, this patch changes it only once but after that it is everywhere :)
(It was mentioned in another place already)

> Looks good to me.
> 
> Reviewed-by: Jean Delvare <jdelvare@suse.de>

Thanks!

On Mon, Mar 11, 2019 at 11:33:34PM +0100, Wolfram Sang wrote:
> The text describing the address to be used did not reflect the recent
> change where some of the functionality of '-f' has been seperated into
> '-a'.
> 
> Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>

Applied to master.