@@ -6,16 +6,12 @@
*/
#include <common.h>
-#include <mmc.h>
#include <asm/io.h>
#include <asm/arch/sama5d3_smc.h>
#include <asm/arch/at91_common.h>
#include <asm/arch/at91_rstc.h>
#include <asm/arch/gpio.h>
#include <asm/arch/clk.h>
-#include <atmel_mci.h>
-#include <net.h>
-#include <netdev.h>
#include <spl.h>
#include <asm/arch/atmel_mpddrc.h>
#include <asm/arch/at91_wdt.h>
@@ -65,20 +61,12 @@ static void sama5d3_xplained_usb_hw_init(void)
#ifdef CONFIG_GENERIC_ATMEL_MCI
static void sama5d3_xplained_mci0_hw_init(void)
{
- at91_mci_hw_init();
-
at91_set_pio_output(AT91_PIO_PORTE, 2, 0); /* MCI0 Power */
}
#endif
int board_early_init_f(void)
{
- at91_periph_clk_enable(ATMEL_ID_PIOA);
- at91_periph_clk_enable(ATMEL_ID_PIOB);
- at91_periph_clk_enable(ATMEL_ID_PIOC);
- at91_periph_clk_enable(ATMEL_ID_PIOD);
- at91_periph_clk_enable(ATMEL_ID_PIOE);
-
at91_seriald_hw_init();
return 0;
@@ -98,10 +86,6 @@ int board_init(void)
#ifdef CONFIG_GENERIC_ATMEL_MCI
sama5d3_xplained_mci0_hw_init();
#endif
-#ifdef CONFIG_MACB
- at91_gmac_hw_init();
- at91_macb_hw_init();
-#endif
return 0;
}
@@ -113,24 +97,6 @@ int dram_init(void)
return 0;
}
-int board_eth_init(bd_t *bis)
-{
-#ifdef CONFIG_MACB
- macb_eth_initialize(0, (void *)ATMEL_BASE_GMAC, 0x00);
- macb_eth_initialize(0, (void *)ATMEL_BASE_EMAC, 0x00);
-#endif
- return 0;
-}
-
-#ifdef CONFIG_GENERIC_ATMEL_MCI
-int board_mmc_init(bd_t *bis)
-{
- atmel_mci_init((void *)ATMEL_BASE_MCI0);
-
- return 0;
-}
-#endif
-
/* SPL */
#ifdef CONFIG_SPL_BUILD
void spl_board_init(void)
Due to the introduction of the pinctrl and clk driver, and using device tree files, remove the unneeded hardcoded pin configuration and clock enabling code from the board file. Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com> --- Changes in v4: None Changes in v3: None Changes in v2: None board/atmel/sama5d3_xplained/sama5d3_xplained.c | 34 ------------------------- 1 file changed, 34 deletions(-)