Message ID | 1463378070-2900-5-git-send-email-lokeshvutla@ti.com |
---|---|
State | Accepted |
Delegated to: | Tom Rini |
Headers | show |
On Mon, May 16, 2016 at 11:24:27AM +0530, Lokesh Vutla wrote: > From: Mugunthan V N <mugunthanvnm@ti.com> > > As per mmc device tree binding documentation card detect gpio has > to be active low signal. When a hardware is designed with active > high card detect, gpio polarity has to be changed with > cd-inverted dt property. > > In AM335x the card detect gpio is designed as active low gpio. > So correcting the dt card detect gpio definition. > > Reviewed-by: Tom Rini <trini@konsulko.com> > Signed-off-by: Mugunthan V N <mugunthanvnm@ti.com> Applied to u-boot/master, thanks!
diff --git a/arch/arm/dts/am335x-bone-common.dtsi b/arch/arm/dts/am335x-bone-common.dtsi index a00c0cd..40a3c35 100644 --- a/arch/arm/dts/am335x-bone-common.dtsi +++ b/arch/arm/dts/am335x-bone-common.dtsi @@ -388,8 +388,7 @@ bus-width = <0x4>; pinctrl-names = "default"; pinctrl-0 = <&mmc1_pins>; - cd-gpios = <&gpio0 6 GPIO_ACTIVE_HIGH>; - cd-inverted; + cd-gpios = <&gpio0 6 GPIO_ACTIVE_LOW>; }; &aes { diff --git a/arch/arm/dts/am335x-evm.dts b/arch/arm/dts/am335x-evm.dts index c0bc2af..a6f20af 100644 --- a/arch/arm/dts/am335x-evm.dts +++ b/arch/arm/dts/am335x-evm.dts @@ -717,7 +717,7 @@ bus-width = <4>; pinctrl-names = "default"; pinctrl-0 = <&mmc1_pins>; - cd-gpios = <&gpio0 6 GPIO_ACTIVE_HIGH>; + cd-gpios = <&gpio0 6 GPIO_ACTIVE_LOW>; }; &mmc3 {