| Message ID | 1410886138-22910-6-git-send-email-nitin.garg@freescale.com |
|---|---|
| State | Changes Requested |
| Delegated to: | Stefano Babic |
| Headers | show |
diff --git a/include/configs/mx6sabre_common.h b/include/configs/mx6sabre_common.h index e59a3b4..4297596 100644 --- a/include/configs/mx6sabre_common.h +++ b/include/configs/mx6sabre_common.h @@ -24,6 +24,7 @@ #define CONFIG_SETUP_MEMORY_TAGS #define CONFIG_INITRD_TAG #define CONFIG_REVISION_TAG +#define CONFIG_IMX6_THERMAL #define CONFIG_SYS_GENERIC_BOARD @@ -37,7 +38,7 @@ #define CONFIG_MXC_UART #define CONFIG_CMD_FUSE -#ifdef CONFIG_CMD_FUSE +#if defined(CONFIG_CMD_FUSE) || defined(CONFIG_IMX6_THERMAL) #define CONFIG_MXC_OCOTP #endif
Add CONFIG_IMX6_THERMAL to mx6sabre_common.h file. Since thermal driver depends on ocotp, make sure to enable CONFIG_MXC_OCOTP when CONFIG_IMX6_THERMAL is slected. Signed-off-by: Nitin Garg <nitin.garg@freescale.com> --- Changes in v4: -Added imx6 thermal sensor as a driver -Renamed the config define to be more meaningful -Move the clock code to clock.c -Reusing ocotp driver for reading fuse -Fix check for calibration fuse not programmed -Aligned the slope computation with kernel -Added Anadig register defines as seperate commit Changes in v3: -adds the mx6 temperature support -adds the mx6 temperature support to mx6sabresd board. Changes in v2: -run checkpatch and fix reported issues include/configs/mx6sabre_common.h | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)