diff mbox

[U-Boot,v2,5/5] arm: omap3: Add HEAD acoustics (HA) board variant omap3_ha to tao3530

Message ID 1386145657-27146-5-git-send-email-sr@denx.de
State Accepted
Delegated to: Tom Rini
Headers show

Commit Message

Stefan Roese Dec. 4, 2013, 8:27 a.m. UTC 
The Head acoustics (HA) baseboard used the Technexion TAO3530 SOM
and has only some minor differences to the Technexion Thunder baseboard.
This patch adds support for this HA baseboard / TAO3530 as the "omap3_ha"
build target.

Signed-off-by: Stefan Roese <sr@denx.de>
Cc: Tapani Utriainen <tapani@technexion.com>
Cc: Thorsten Eisbein <thorsten.eisbein@head-acoustics.de>
Cc: Tom Rini <trini@ti.com>
---
v2:
- Remove "\n" in sysinfo string

 board/technexion/tao3530/tao3530.c | 15 +++++++++++++++
 board/technexion/tao3530/tao3530.h |  7 +++++++
 boards.cfg                         |  1 +
 3 files changed, 23 insertions(+)

Comments

Tom Rini Dec. 13, 2013, 12:48 p.m. UTC | #1 
On Wed, Dec 04, 2013 at 09:27:37AM +0100, Stefan Roese wrote:

> The Head acoustics (HA) baseboard used the Technexion TAO3530 SOM
> and has only some minor differences to the Technexion Thunder baseboard.
> This patch adds support for this HA baseboard / TAO3530 as the "omap3_ha"
> build target.
> 
> Signed-off-by: Stefan Roese <sr@denx.de>
> Cc: Tapani Utriainen <tapani@technexion.com>
> Cc: Thorsten Eisbein <thorsten.eisbein@head-acoustics.de>
> Cc: Tom Rini <trini@ti.com>

Applied to u-boot-ti/master, thanks!
diff mbox

Patch

diff --git a/board/technexion/tao3530/tao3530.c b/board/technexion/tao3530/tao3530.c
index 5041eaf..44a8240 100644
--- a/board/technexion/tao3530/tao3530.c
+++ b/board/technexion/tao3530/tao3530.c
@@ -75,6 +75,18 @@  out:
  */
 void get_board_mem_timings(struct board_sdrc_timings *timings)
 {
+#if defined(CONFIG_SYS_BOARD_OMAP3_HA)
+	/*
+	 * Switch baseboard LED to red upon power-on
+	 */
+	MUX_OMAP3_HA();
+
+	/* Request a gpio before using it */
+	gpio_request(111, "");
+	/* Sets the gpio as output and its value to 1, switch LED to red */
+	gpio_direction_output(111, 1);
+#endif
+
 	if (tao3530_revision() < 3) {
 		/* 256MB / Bank */
 		timings->mcfg = MCFG(256 << 20, 14);	/* RAS-width 14 */
@@ -162,6 +174,9 @@  int misc_init_r(void)
 void set_muxconf_regs(void)
 {
 	MUX_TAO3530();
+#if defined(CONFIG_SYS_BOARD_OMAP3_HA)
+	MUX_OMAP3_HA();
+#endif
 }
 
 #if defined(CONFIG_GENERIC_MMC) && !defined(CONFIG_SPL_BUILD)
diff --git a/board/technexion/tao3530/tao3530.h b/board/technexion/tao3530/tao3530.h
index 1ea767d..daff109 100644
--- a/board/technexion/tao3530/tao3530.h
+++ b/board/technexion/tao3530/tao3530.h
@@ -9,7 +9,11 @@ 
 
 const omap3_sysinfo sysinfo = {
 	DDR_STACKED,
+#if defined(CONFIG_SYS_BOARD_OMAP3_HA)
+	"HEAD acoustics OMAP3-HA",
+#else
 	"OMAP3 TAO-3530 board",
+#endif
 	"NAND",
 };
 
@@ -361,4 +365,7 @@  const omap3_sysinfo sysinfo = {
 	MUX_VAL(CP(SDRC_CKE0),	(IDIS | PTU | EN  | M0)) \
 	MUX_VAL(CP(SDRC_CKE1),	(IDIS | PTU | EN  | M0))
 
+#define MUX_OMAP3_HA() \
+	MUX_VAL(CP(CAM_XCLKB),	(IDIS | PTD | DIS | M4)) /* GPIO_111 */
+
 #endif
diff --git a/boards.cfg b/boards.cfg
index a00d499..1ba2a53 100644
--- a/boards.cfg
+++ b/boards.cfg
@@ -325,6 +325,7 @@  Active  arm         armv7          omap3       logicpd         zoom1
 Active  arm         armv7          omap3       logicpd         zoom2               omap3_zoom2                          -                                                                                                                                 Tom Rix <Tom.Rix@windriver.com>
 Active  arm         armv7          omap3       matrix_vision   mvblx               omap3_mvblx                          -                                                                                                                                 Michael Jones <michael.jones@matrix-vision.de>
 Active  arm         armv7          omap3       nokia           rx51                nokia_rx51                           -                                                                                                                                 Pali Rohár <pali.rohar@gmail.com>
+Active  arm         armv7          omap3       technexion      tao3530             omap3_ha                             tao3530:SYS_BOARD_OMAP3_HA                                                                                                        Stefan Roese <sr@denx.de>
 Active  arm         armv7          omap3       technexion      tao3530             tao3530                              -                                                                                                                                 Tapani Utriainen <linuxfae@technexion.com>
 Active  arm         armv7          omap3       technexion      twister             twister                              -                                                                                                                                 Stefano Babic <sbabic@denx.de>
 Active  arm         armv7          omap3       teejet          mt_ventoux          mt_ventoux                           -                                                                                                                                 Stefano Babic <sbabic@denx.de>