@@ -142,6 +142,7 @@ void i2c_init_board(void)
}
#endif
+#if defined(CONFIG_KM_COMMON_ETH_INIT)
int board_eth_init(bd_t *bis)
{
if (ethernet_present())
@@ -149,6 +150,7 @@ int board_eth_init(bd_t *bis)
return -1;
}
+#endif
/*
* do_setboardid command
@@ -17,6 +17,9 @@
#define CONFIG_CMD_DTT
#define CONFIG_JFFS2_CMDLINE
+/* standard km ethernet_present for piggy */
+#define CONFIG_KM_COMMON_ETH_INIT
+
/* EEprom support 24C08, 24C16, 24C64 */
#define CONFIG_SYS_I2C_MULTI_EEPROMS
#define CONFIG_SYS_EEPROM_PAGE_WRITE_ENABLE
@@ -164,6 +164,7 @@
#define CONFIG_MVGBE_PORTS {1, 0} /* enable port 0 only */
#define CONFIG_PHY_BASE_ADR 0
#define CONFIG_ENV_OVERWRITE /* ethaddr can be reprogrammed */
+#define CONFIG_KM_COMMON_ETH_INIT /* standard km ethernet_present for piggy */
/*
* UBI related stuff
This must be defined by a board support file that want to use the keymile common.c board_eth_init function that requires ethernet_present to be defined. Currently all the km architectures use it but the kmp204x architecture later supported in this series does use another board_eth_init function and thus does not define it. Signed-off-by: Valentin Longchamp <valentin.longchamp@keymile.com> --- Changes in v3: None Changes in v2: - add CONFIG_KM_COMMON_ETH_INIT for the km board that need the common.c board_eth_init board/keymile/common/common.c | 2 ++ include/configs/km/km-powerpc.h | 3 +++ include/configs/km/km_arm.h | 1 + 3 files changed, 6 insertions(+)