Message ID | 20230711090918.523772-6-marcel@ziswiler.com |
---|---|
State | Accepted |
Commit | 214a986f132d749532fa15835498e1a6b723e191 |
Delegated to: | Stefano Babic |
Headers | show |
Series | verdin-imx8mm/verdin-imx8mp: fix ctrl_sleep_moci# handling | expand |
> From: Andrejs Cainikovs <andrejs.cainikovs@toradex.com> > Drive CTRL_SLEEP_MOCI# high at boot (SPL) using a GPIO hog, this signal > may be used to control some power-rails on the carrier board, therefore > it should be set to high when the module is booting. > To do this as early as possible is generally a good idea and the issue > was noticed on the Yavia carrier board where it is needed to power the > I2C EEPROM on the carrier board. > Signed-off-by: Andrejs Cainikovs <andrejs.cainikovs@toradex.com> > Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com> Applied to u-boot-imx, master, thanks ! Best regards, Stefano Babic
diff --git a/arch/arm/dts/imx8mp-verdin-wifi-dev-u-boot.dtsi b/arch/arm/dts/imx8mp-verdin-wifi-dev-u-boot.dtsi index 9c6c417f7ee..0162f9b2da3 100644 --- a/arch/arm/dts/imx8mp-verdin-wifi-dev-u-boot.dtsi +++ b/arch/arm/dts/imx8mp-verdin-wifi-dev-u-boot.dtsi @@ -62,6 +62,10 @@ &gpio4 { bootph-pre-ram; + + ctrl-sleep-moci-hog { + bootph-pre-ram; + }; }; &gpio5 { @@ -106,6 +110,10 @@ bootph-pre-ram; }; +&pinctrl_ctrl_sleep_moci { + bootph-pre-ram; +}; + &pinctrl_i2c1 { bootph-pre-ram; };