@@ -658,6 +658,7 @@ dtb-$(CONFIG_MACH_SUN50I_H6) += \
sun50i-h6-orangepi-lite2.dtb \
sun50i-h6-orangepi-one-plus.dtb \
sun50i-h6-pine-h64.dtb \
+ sun50i-h6-pine-h64-model-b.dtb \
sun50i-h6-tanix-tx6.dtb
dtb-$(CONFIG_MACH_SUN50I_H616) += \
sun50i-h616-orangepi-zero2.dtb
new file mode 100644
@@ -0,0 +1,51 @@
+// SPDX-License-Identifier: (GPL-2.0+ or MIT)
+/*
+ * Copyright (C) 2019 Corentin LABBE <clabbe@baylibre.com>
+ */
+
+#include "sun50i-h6-pine-h64.dts"
+
+/ {
+ model = "Pine H64 model B";
+ compatible = "pine64,pine-h64-model-b", "allwinner,sun50i-h6";
+
+ /delete-node/ reg_gmac_3v3;
+
+ wifi_pwrseq: wifi_pwrseq {
+ compatible = "mmc-pwrseq-simple";
+ reset-gpios = <&r_pio 1 3 GPIO_ACTIVE_LOW>; /* PM3 */
+ post-power-on-delay-ms = <200>;
+ };
+};
+
+&hdmi_connector {
+ /delete-property/ ddc-en-gpios;
+};
+
+&emac {
+ phy-supply = <®_aldo2>;
+};
+
+&mmc1 {
+ vmmc-supply = <®_cldo3>;
+ vqmmc-supply = <®_aldo1>;
+ mmc-pwrseq = <&wifi_pwrseq>;
+ bus-width = <4>;
+ non-removable;
+ status = "okay";
+};
+
+&uart1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
+ uart-has-rtscts;
+ status = "okay";
+
+ bluetooth {
+ compatible = "realtek,rtl8723bs-bt";
+ device-wake-gpios = <&r_pio 1 2 GPIO_ACTIVE_HIGH>; /* PM2 */
+ host-wake-gpios = <&r_pio 1 1 GPIO_ACTIVE_HIGH>; /* PM1 */
+ enable-gpios = <&r_pio 1 4 GPIO_ACTIVE_HIGH>; /* PM4 */
+ max-speed = <1500000>;
+ };
+};
Add the device-tree for pine H64 model B from 5.15 mainline linux. The differences between the pine H64 boards model A and model B are irrelevant inside u-boot, but the device-tree name is relevant as default for selecting the correct device-tree when booting linux. Signed-off-by: Daniel Wagenknecht <dwagenk@mailbox.org> --- arch/arm/dts/Makefile | 1 + arch/arm/dts/sun50i-h6-pine-h64-model-b.dts | 51 +++++++++++++++++++++ 2 files changed, 52 insertions(+) create mode 100644 arch/arm/dts/sun50i-h6-pine-h64-model-b.dts