@@ -30,7 +30,7 @@ CONFIG_SPL_LOAD_FIT=y
CONFIG_SPL_LOAD_FIT_ADDRESS=0x81000000
# CONFIG_USE_SPL_FIT_GENERATOR is not set
CONFIG_OF_BOARD_SETUP=y
-CONFIG_BOOTCOMMAND="run findfdt; run envboot; run init_${boot}; run boot_rprocs; run get_kern_${boot}; run get_fdt_${boot}; run get_overlay_${boot}; run run_kern"
+CONFIG_BOOTCOMMAND="run findfdt; run envboot; run init_${boot}; run main_cpsw0_qsgmii_phyinit; run boot_rprocs; run get_kern_${boot}; run get_fdt_${boot}; run get_overlay_${boot}; run run_kern"
CONFIG_LOGLEVEL=7
CONFIG_SPL_BOARD_INIT=y
CONFIG_SPL_SYS_MALLOC_SIMPLE=y
Update the default BOOTCOMMAND to provide an automatic and easier way to configure ethernet PHY before loading the firmware. Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com> --- configs/j7200_evm_a72_defconfig | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)