@@ -18,7 +18,6 @@ CONFIG_SPL_LOAD_FIT=y
CONFIG_USE_BOOTCOMMAND=y
# CONFIG_DISPLAY_CPUINFO is not set
CONFIG_SPL_TEXT_BASE=0x41c00000
-CONFIG_SPL_SYS_MALLOC_SIMPLE=y
CONFIG_SPL_STACK_R=y
CONFIG_SPL_SEPARATE_BSS=y
CONFIG_SPL_I2C_SUPPORT=y
@@ -20,7 +20,6 @@ CONFIG_SPL_FIT_IMAGE_POST_PROCESS=y
CONFIG_USE_BOOTCOMMAND=y
# CONFIG_DISPLAY_CPUINFO is not set
CONFIG_SPL_TEXT_BASE=0x41c00000
-CONFIG_SPL_SYS_MALLOC_SIMPLE=y
CONFIG_SPL_STACK_R=y
CONFIG_SPL_SEPARATE_BSS=y
CONFIG_SPL_I2C_SUPPORT=y
@@ -41,6 +41,9 @@
CONFIG_SPL_BSS_MAX_SIZE)
/* Set the stack right below the SPL BSS section */
#define CONFIG_SYS_INIT_SP_ADDR CONFIG_SPL_BSS_START_ADDR
+/* Configure R5 SPL post-relocation malloc pool in DDR */
+#define CONFIG_SYS_SPL_MALLOC_START 0x84000000
+#define CONFIG_SYS_SPL_MALLOC_SIZE SZ_16M
#endif
#ifdef CONFIG_SYS_K3_SPL_ATF
Switch to using the full malloc scheme in post-relocation SPL to allow better utilization of available memory for example by allowing memory to get freed. Initially allocate a 16MB-sized region in DDR starting at address 0x84000000 for this purpose. Signed-off-by: Andreas Dannenberg <dannenberg@ti.com> --- configs/am65x_evm_r5_defconfig | 1 - configs/am65x_hs_evm_r5_defconfig | 1 - include/configs/am65x_evm.h | 3 +++ 3 files changed, 3 insertions(+), 2 deletions(-)