diff mbox

[U-Boot,01/11] mmc: sdhci: disable the 8bit mode when host doesn't support it

Message ID 20161230063021.23756-2-jh80.chung@samsung.com
State Accepted
Commit ecd7b246f69640dfe8e28a5c78f245b8a43a4435
Delegated to: Jaehoon Chung
Headers show

Commit Message

Jaehoon Chung Dec. 30, 2016, 6:30 a.m. UTC
Buswidth is depeneded on Hardware schematic.
Evne though host can support the 8bit buswidth, if hardware doesn't
support 8bit mode, it doesn't work fine.
So the buswidth mode selection leaves a matter in each SoC drivers.

On the contrary to this, hardware supports 8bit mode, but host doesn't
support it. then controller has to disable the MMC_MODE_8BIT.
(Host can check whether 8bit mode is supported or not, since V3.0)

Signed-off-by: Jaehoon Chung <jh80.chung@samsung.com>
---
 drivers/mmc/sdhci.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)
diff mbox

Patch

diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c
index cbf5f56..853c268 100644
--- a/drivers/mmc/sdhci.c
+++ b/drivers/mmc/sdhci.c
@@ -594,14 +594,13 @@  int sdhci_setup_cfg(struct mmc_config *cfg, struct sdhci_host *host,
 
 	cfg->host_caps = MMC_MODE_HS | MMC_MODE_HS_52MHz | MMC_MODE_4BIT;
 	if (SDHCI_GET_VERSION(host) >= SDHCI_SPEC_300) {
-		if (caps & SDHCI_CAN_DO_8BIT)
-			cfg->host_caps |= MMC_MODE_8BIT;
+		if (!(caps & SDHCI_CAN_DO_8BIT))
+			cfg->host_caps &= ~MMC_MODE_8BIT;
 	}
 
 	if (host->host_caps)
 		cfg->host_caps |= host->host_caps;
 
-
 	cfg->b_max = CONFIG_SYS_MMC_MAX_BLK_COUNT;
 
 	/*