Message ID | 1412277413-30271-18-git-send-email-eric.nelson@boundarydevices.com |
---|---|
State | Awaiting Upstream |
Delegated to: | Stefano Babic |
Headers | show |
On 02/10/2014 21:16, Eric Nelson wrote: > Add support for WVGA (800x480) panels using VESA GTF timings over > LVDS. > > No auto-detection is supported, so you must configure this panel > manually through the 'panel' environment variable: > > U-Boot > setenv panel svga > U-Boot > saveenv && reset > > Signed-off-by: Eric Nelson <eric.nelson@boundarydevices.com> > --- Applied to u-boot-imx, thanks ! Best regards, Stefano Babic
diff --git a/board/boundary/nitrogen6x/nitrogen6x.c b/board/boundary/nitrogen6x/nitrogen6x.c index c91e0c4..115ee81 100644 --- a/board/boundary/nitrogen6x/nitrogen6x.c +++ b/board/boundary/nitrogen6x/nitrogen6x.c @@ -680,6 +680,26 @@ struct display_info_t const displays[] = {{ .sync = FB_SYNC_EXT, .vmode = FB_VMODE_NONINTERLACED } }, { + .bus = 0, + .addr = 0, + .pixfmt = IPU_PIX_FMT_LVDS666, + .detect = 0, + .enable = enable_lvds, + .mode = { + .name = "wvga-lvds", + .refresh = 57, + .xres = 800, + .yres = 480, + .pixclock = 15385, + .left_margin = 220, + .right_margin = 40, + .upper_margin = 21, + .lower_margin = 7, + .hsync_len = 60, + .vsync_len = 10, + .sync = FB_SYNC_EXT, + .vmode = FB_VMODE_NONINTERLACED +} }, { .bus = 2, .addr = 0x48, .pixfmt = IPU_PIX_FMT_RGB666,
Add support for WVGA (800x480) panels using VESA GTF timings over LVDS. No auto-detection is supported, so you must configure this panel manually through the 'panel' environment variable: U-Boot > setenv panel svga U-Boot > saveenv && reset Signed-off-by: Eric Nelson <eric.nelson@boundarydevices.com> --- board/boundary/nitrogen6x/nitrogen6x.c | 20 ++++++++++++++++++++ 1 file changed, 20 insertions(+)