Message ID | 1412277413-30271-16-git-send-email-eric.nelson@boundarydevices.com |
---|---|
State | Awaiting Upstream |
Delegated to: | Stefano Babic |
Headers | show |
On 02/10/2014 21:16, Eric Nelson wrote: > Add support for 800x600 18-bit RGB displays using VESA GTF timings. > > No auto-detection is supported, so you must configure this panel > manually through the 'panel' environment variable: > > U-Boot > setenv panel svga > U-Boot > saveenv && reset > > Signed-off-by: Eric Nelson <eric.nelson@boundarydevices.com> > --- Applied to u-boot-imx, thanks ! Best regards, Stefano Babic
diff --git a/board/boundary/nitrogen6x/nitrogen6x.c b/board/boundary/nitrogen6x/nitrogen6x.c index b1d85da..6695f87 100644 --- a/board/boundary/nitrogen6x/nitrogen6x.c +++ b/board/boundary/nitrogen6x/nitrogen6x.c @@ -640,6 +640,26 @@ struct display_info_t const displays[] = {{ .sync = 0x40000002, .vmode = FB_VMODE_NONINTERLACED } }, { + .bus = 0, + .addr = 0, + .pixfmt = IPU_PIX_FMT_RGB666, + .detect = NULL, + .enable = enable_rgb, + .mode = { + .name = "svga", + .refresh = 60, + .xres = 800, + .yres = 600, + .pixclock = 15385, + .left_margin = 220, + .right_margin = 40, + .upper_margin = 21, + .lower_margin = 7, + .hsync_len = 60, + .vsync_len = 10, + .sync = 0, + .vmode = FB_VMODE_NONINTERLACED +} }, { .bus = 2, .addr = 0x48, .pixfmt = IPU_PIX_FMT_RGB666,
Add support for 800x600 18-bit RGB displays using VESA GTF timings. No auto-detection is supported, so you must configure this panel manually through the 'panel' environment variable: U-Boot > setenv panel svga U-Boot > saveenv && reset Signed-off-by: Eric Nelson <eric.nelson@boundarydevices.com> --- board/boundary/nitrogen6x/nitrogen6x.c | 20 ++++++++++++++++++++ 1 file changed, 20 insertions(+)