Message ID | 20210301223337.7763-1-tharvey@gateworks.com |
---|---|
Headers | show |
Series | imx: ventana: convert Gateworks Ventana to dm | expand |
On Mon, Mar 1, 2021 at 2:33 PM Tim Harvey <tharvey@gateworks.com> wrote: > > This is the first series converting the IMX6 basd Gateworks Ventana > boards to driver-model. > > This series resolves some issues with NAND SPL (non DM SPL) in order > to read the FIT image. Additionally it covers conversions to DM_USB, > DM_MMC, DM_MTD, and DM_SPI. > > Remaining items are DM_PCI and DM_ETH which I'm still working through. > > Tim > > Tim Harvey (11): > spl: fit: nand: skip bad block handling if NAND chip not fully defined > spl: fit: nand: allow for non-page-aligned elements > dt-bindings: add tda1997x and bindings > imx: ventana: add Gateworks Ventana dts > arm: dts: imx6qdl-gw*: add dr_mode prop to dt to avoid error > imx: ventana: convert U-Boot to OF_CONTROL using FIT image > imx: ventana: add pinctrl and remove unneeded UART init and config > imx: ventana: enable dm support for USB > imx: ventana: enable dm support for MMC and SATA > imx: ventana: enable dm for MTD and NAND > imx: ventana: enable dm for SPI > Stefano, I'm ready to send a v2 of this patch series. Have you had a chance to review these yet? Tom reviewed the first three and I have an update to the commit log pending to state what Linux kernel the tda1997x bindings come from but I have not had any comments on the rest of the series. There may have been an issue with my mail server when I sent them so they may have got missed. Best Regards, Tim