@@ -86,5 +86,8 @@ int tpm_tis_pre_save(TPMState *s);
void tpm_tis_reset(TPMState *s);
enum TPMVersion tpm_tis_get_tpm_version(TPMState *s);
void tpm_tis_request_completed(TPMState *s, int ret);
+uint32_t tpm_tis_read_data(TPMState *s, hwaddr addr, unsigned size);
+void tpm_tis_write_data(TPMState *s, hwaddr addr, uint64_t val, uint32_t size);
+uint16_t tpm_tis_get_checksum(TPMState *s);
#endif /* TPM_TPM_TIS_H */
@@ -26,6 +26,8 @@
#include "hw/irq.h"
#include "hw/isa/isa.h"
#include "qapi/error.h"
+#include "qemu/bswap.h"
+#include "qemu/crc-ccitt.h"
#include "qemu/module.h"
#include "hw/acpi/tpm.h"
@@ -447,6 +449,23 @@ static uint64_t tpm_tis_mmio_read(void *opaque, hwaddr addr,
return val;
}
+/*
+ * A wrapper read function so that it can be directly called without
+ * mmio.
+ */
+uint32_t tpm_tis_read_data(TPMState *s, hwaddr addr, unsigned size)
+{
+ return tpm_tis_mmio_read(s, addr, size);
+}
+
+/*
+ * Calculate current data buffer checksum
+ */
+uint16_t tpm_tis_get_checksum(TPMState *s)
+{
+ return bswap16(crc_ccitt(0, s->buffer, s->rw_offset));
+}
+
/*
* Write a value to a register of the TIS interface
* See specs pages 33-63 for description of the registers
@@ -767,6 +786,15 @@ static void tpm_tis_mmio_write(void *opaque, hwaddr addr,
}
}
+/*
+ * A wrapper write function so that it can be directly called without
+ * mmio.
+ */
+void tpm_tis_write_data(TPMState *s, hwaddr addr, uint64_t val, uint32_t size)
+{
+ tpm_tis_mmio_write(s, addr, val, size);
+}
+
const MemoryRegionOps tpm_tis_memory_ops = {
.read = tpm_tis_mmio_read,
.write = tpm_tis_mmio_write,
@@ -93,6 +93,7 @@
#define TPM_TIS_CAP_DATA_TRANSFER_64B (3 << 9)
#define TPM_TIS_CAP_DATA_TRANSFER_LEGACY (0 << 9)
#define TPM_TIS_CAP_BURST_COUNT_DYNAMIC (0 << 8)
+#define TPM_TIS_CAP_BURST_COUNT_STATIC (1 << 8)
#define TPM_TIS_CAP_INTERRUPT_LOW_LEVEL (1 << 4) /* support is mandatory */
#define TPM_TIS_CAPABILITIES_SUPPORTED1_3 \
(TPM_TIS_CAP_INTERRUPT_LOW_LEVEL | \
@@ -209,6 +210,33 @@ REG32(CRB_DATA_BUFFER, 0x80)
#define TPM_PPI_FUNC_ALLOWED_USR_NOT_REQ (4 << 0)
#define TPM_PPI_FUNC_MASK (7 << 0)
+/* TPM TIS I2C registers */
+#define TPM_I2C_REG_LOC_SEL 0x00
+#define TPM_I2C_REG_ACCESS 0x04
+#define TPM_I2C_REG_INT_ENABLE 0x08
+#define TPM_I2C_REG_INT_CAPABILITY 0x14
+#define TPM_I2C_REG_STS 0x18
+#define TPM_I2C_REG_DATA_FIFO 0x24
+#define TPM_I2C_REG_INTF_CAPABILITY 0x30
+#define TPM_I2C_REG_I2C_DEV_ADDRESS 0x38
+#define TPM_I2C_REG_DATA_CSUM_ENABLE 0x40
+#define TPM_I2C_REG_DATA_CSUM_GET 0x44
+#define TPM_I2C_REG_DID_VID 0x48
+#define TPM_I2C_REG_RID 0x4c
+#define TPM_I2C_REG_UNKNOWN 0xff
+
+/* I2C specific interface capabilities */
+#define TPM_I2C_CAP_INTERFACE_TYPE (0x2 << 0) /* FIFO interface */
+#define TPM_I2C_CAP_INTERFACE_VER (0x0 << 4) /* TCG I2C intf 1.0 */
+#define TPM_I2C_CAP_TPM2_FAMILY (0x1 << 7) /* TPM 2.0 family. */
+#define TPM_I2C_CAP_DEV_ADDR_CHANGE (0x0 << 27) /* No dev addr chng */
+#define TPM_I2C_CAP_BURST_COUNT_STATIC (0x1 << 29) /* Burst count static */
+#define TPM_I2C_CAP_LOCALITY_CAP (0x1 << 25) /* 0-5 locality */
+#define TPM_I2C_CAP_BUS_SPEED (3 << 21) /* std and fast mode */
+
+/* TPM_STS mask for read bits 31:26 must be zero */
+#define TPM_I2C_STS_READ_MASK 0x03ffffff
+
void tpm_build_ppi_acpi(TPMIf *tpm, Aml *dev);
#endif /* CONFIG_TPM */
Qemu already supports devices attached to ISA and sysbus. This drop adds support for the I2C bus attached TPM devices. This commit includes changes for the common code. - Added support for the new checksum registers which are required for the I2C support. The checksum calculation is handled in the qemu common code. - Added wrapper function for read and write data so that I2C code can call it without MMIO interface. Signed-off-by: Ninad Palsule <ninad@linux.ibm.com> --- V2: Incorporated Stephen's comments. - Removed checksum enable and checksum get registers. - Added checksum calculation function which can be called from i2c layer. --- V3: Incorporated review comments from Cedric and Stefan. - Pass locality to the checksum calculation function and cleanup - Moved I2C related definations in the acpi/tpm.h --- V4: Incorporated review comments by Stefan - Remove the check for locality while calculating checksum - Use bswap16 instead of cpu_ti_be16. - Rename TPM_I2C register by dropping _TIS_ from it. --- hw/tpm/tpm_tis.h | 3 +++ hw/tpm/tpm_tis_common.c | 28 ++++++++++++++++++++++++++++ include/hw/acpi/tpm.h | 28 ++++++++++++++++++++++++++++ 3 files changed, 59 insertions(+)