@@ -39,7 +39,6 @@ Table : Subdirectories in /proc/sys/net
802 E802 protocol ax25 AX25
ethernet Ethernet protocol rose X.25 PLP layer
ipv4 IP version 4 x25 X.25 protocol
- ipx IPX token-ring IBM token ring
bridge Bridging decnet DEC net
ipv6 IP version 6 tipc TIPC
========= =================== = ========== ==================
@@ -401,33 +400,7 @@ interface.
(network) that the route leads to, the router (may be directly connected), the
route flags, and the device the route is using.
-
-5. IPX
-------
-
-The IPX protocol has no tunable values in proc/sys/net.
-
-The IPX protocol does, however, provide proc/net/ipx. This lists each IPX
-socket giving the local and remote addresses in Novell format (that is
-network:node:port). In accordance with the strange Novell tradition,
-everything but the port is in hex. Not_Connected is displayed for sockets that
-are not tied to a specific remote address. The Tx and Rx queue sizes indicate
-the number of bytes pending for transmission and reception. The state
-indicates the state the socket is in and the uid is the owning uid of the
-socket.
-
-The /proc/net/ipx_interface file lists all IPX interfaces. For each interface
-it gives the network number, the node number, and indicates if the network is
-the primary network. It also indicates which device it is bound to (or
-Internal for internal networks) and the Frame Type if appropriate. Linux
-supports 802.3, 802.2, 802.2 SNAP and DIX (Blue Book) ethernet framing for
-IPX.
-
-The /proc/net/ipx_route table holds a list of IPX routes. For each route it
-gives the destination network, the router node (or Directly) and the network
-address of the router (or Connected) for internal networks.
-
-6. TIPC
+5. TIPC
-------
tipc_rmem
Both IPX and TR have not been supported for a while now. Remove them from the /proc/sys/net documentation. Signed-off-by: Stephen Hemminger <stephen@networkplumber.org> --- Documentation/admin-guide/sysctl/net.rst | 29 +----------------------- 1 file changed, 1 insertion(+), 28 deletions(-)