@@ -11,6 +11,7 @@
#include <linux/spi/spi.h>
#include <linux/errno.h>
#include <linux/gpio/consumer.h>
+#include <linux/phylink.h>
#include <linux/of.h>
#include <linux/of_net.h>
#include <linux/of_mdio.h>
@@ -747,6 +748,35 @@ static void sja1105_adjust_link(struct dsa_switch *ds, int port,
sja1105_adjust_port_config(priv, port, phydev->speed, true);
}
+static void sja1105_phylink_validate(struct dsa_switch *ds, int port,
+ unsigned long *supported,
+ struct phylink_link_state *state)
+{
+ /* Construct a new mask which exhaustively contains all link features
+ * supported by the MAC, and then apply that (logical AND) to what will
+ * be sent to the PHY for "marketing".
+ */
+ __ETHTOOL_DECLARE_LINK_MODE_MASK(mask) = { 0, };
+ struct sja1105_private *priv = ds->priv;
+ struct sja1105_xmii_params_entry *mii;
+
+ mii = priv->static_config.tables[BLK_IDX_XMII_PARAMS].entries;
+
+ /* The MAC does not support pause frames, and also doesn't
+ * support half-duplex traffic modes.
+ */
+ phylink_set(mask, Autoneg);
+ phylink_set(mask, MII);
+ phylink_set(mask, 10baseT_Full);
+ phylink_set(mask, 100baseT_Full);
+ if (mii->xmii_mode[port] == XMII_MODE_RGMII)
+ phylink_set(mask, 1000baseT_Full);
+
+ bitmap_and(supported, supported, mask, __ETHTOOL_LINK_MODE_MASK_NBITS);
+ bitmap_and(state->advertising, state->advertising, mask,
+ __ETHTOOL_LINK_MODE_MASK_NBITS);
+}
+
#define fdb(bin, index) \
((bin) * SJA1105ET_FDB_BIN_SIZE + (index))
#define is_bin_index_valid(i) \
@@ -1482,6 +1512,7 @@ static const struct dsa_switch_ops sja1105_switch_ops = {
.get_tag_protocol = sja1105_get_tag_protocol,
.setup = sja1105_setup,
.adjust_link = sja1105_adjust_link,
+ .phylink_validate = sja1105_phylink_validate,
.get_strings = sja1105_get_strings,
.get_ethtool_stats = sja1105_get_ethtool_stats,
.get_sset_count = sja1105_get_sset_count,
Ethernet flow control: The switch MAC does not consume, nor does it emit pause frames. It simply forwards them as any other Ethernet frame (and since the DMAC is, per IEEE spec, 01-80-C2-00-00-01, it means they are filtered as link-local traffic and forwarded to the CPU, which can't do anything useful with them). Duplex: There is no duplex setting in the SJA1105 MAC. It is known to forward traffic at line rate on the same port in both directions. Therefore it must be that it only supports full duplex. Signed-off-by: Vladimir Oltean <olteanv@gmail.com> --- Changes in v2: Patch is new. drivers/net/dsa/sja1105/sja1105_main.c | 31 ++++++++++++++++++++++++++ 1 file changed, 31 insertions(+)