@@ -176,6 +176,36 @@ __ATTRIBUTE_GROUPS(dsa_hwmon);
#endif /* CONFIG_NET_DSA_HWMON */
/* basic switch operations **************************************************/
+static int dsa_cpu_dsa_setup(struct dsa_switch *ds, struct net_device *master)
+{
+ struct dsa_chip_data *cd = ds->pd;
+ struct device_node *port_dn;
+ struct phy_device *phydev;
+ int ret, port;
+
+ for (port = 0; port < DSA_MAX_PORTS; port++) {
+ if (!(dsa_is_cpu_port(ds, port) || dsa_is_dsa_port(ds, port)))
+ continue;
+
+ port_dn = cd->port_dn[port];
+ if (of_phy_is_fixed_link(port_dn)) {
+ ret = of_phy_register_fixed_link(port_dn);
+ if (ret) {
+ netdev_err(master,
+ "failed to register fixed PHY\n");
+ return ret;
+ }
+ phydev = of_phy_find_device(port_dn);
+ phydev->is_pseudo_fixed_link = true;
+ genphy_config_init(phydev);
+ genphy_read_status(phydev);
+ if (ds->drv->adjust_link)
+ ds->drv->adjust_link(ds, port, phydev);
+ }
+ }
+ return 0;
+}
+
static int dsa_switch_setup_one(struct dsa_switch *ds, struct device *parent)
{
struct dsa_switch_driver *drv = ds->drv;
@@ -297,6 +327,14 @@ static int dsa_switch_setup_one(struct dsa_switch *ds, struct device *parent)
}
}
+ /* Perform configuration of the CPU and DSA ports */
+ ret = dsa_cpu_dsa_setup(ds, dst->master_netdev);
+ if (ret < 0) {
+ netdev_err(dst->master_netdev, "[%d] : can't configure CPU and DSA ports\n",
+ index);
+ ret = 0;
+ }
+
#ifdef CONFIG_NET_DSA_HWMON
/* If the switch provides a temperature sensor,
* register with hardware monitoring subsystem.
By default, DSA and CPU ports are configured to the maximum speed the switch supports. However there can be use cases where the peer device port is slower. Allow a fixed-link property to be used with the DSA and CPU port in the device tree, and use this information to configure the port. Signed-off-by: Andrew Lunn <andrew@lunn.ch> --- v2: Remove support for multiple CPU ports. --- net/dsa/dsa.c | 38 ++++++++++++++++++++++++++++++++++++++ 1 file changed, 38 insertions(+)