@@ -1819,13 +1819,13 @@ static void tg3_adjust_link(struct net_device *dev)
(6 << TX_LENGTHS_IPG_SHIFT) |
(32 << TX_LENGTHS_SLOT_TIME_SHIFT)));
- if ((phydev->link && tp->link_config.active_speed == SPEED_UNKNOWN) ||
- (!phydev->link && tp->link_config.active_speed != SPEED_UNKNOWN) ||
+ if (phydev->link != tp->old_link ||
phydev->speed != tp->link_config.active_speed ||
phydev->duplex != tp->link_config.active_duplex ||
oldflowctrl != tp->link_config.active_flowctrl)
linkmesg = 1;
+ tp->old_link = phydev->link;
tp->link_config.active_speed = phydev->speed;
tp->link_config.active_duplex = phydev->duplex;
@@ -13352,6 +13352,8 @@ static void __devinit tg3_phy_init_link_config(struct tg3 *tp)
tp->link_config.autoneg = AUTONEG_ENABLE;
tp->link_config.active_speed = SPEED_UNKNOWN;
tp->link_config.active_duplex = DUPLEX_UNKNOWN;
+
+ tp->old_link = -1;
}
static int __devinit tg3_phy_probe(struct tg3 *tp)
@@ -3064,6 +3064,7 @@ struct tg3 {
struct mii_bus *mdio_bus;
int mdio_irq[PHY_MAX_ADDR];
+ int old_link;
u8 phy_addr;
The tg3 driver tried to detect link changes by comparing the tg3 local active_speed member with SPEED_UNKNOWN (or formerly SPEED_INVALID). This check is not correct, since phylib will never set its speed member to either of these two values. The code only appeared to work because tg3 initializes active_speed to SPEED_INVALID during tg3_init_one. This patch introduces a new "old_link" tg3 member and then compares the phy_device's link member against it to detect link state changes. Signed-off-by: Matt Carlson <mcarlson@broadcom.com> --- drivers/net/ethernet/broadcom/tg3.c | 6 ++++-- drivers/net/ethernet/broadcom/tg3.h | 1 + 2 files changed, 5 insertions(+), 2 deletions(-)