diff mbox series

[v2,2/2] mtd: spi-nor: Disable the flash quad mode in spi_nor_restore()

Message ID 1594027356-19088-3-git-send-email-yangyicong@hisilicon.com
State Accepted
Delegated to: Ambarus Tudor
Headers show
Series Add support to Disable the flash quad mode | expand

Commit Message

Yicong Yang July 6, 2020, 9:22 a.m. UTC 
If the flash's quad mode is enabled, it'll remain in the quad mode when
it's removed. If we drive the flash next time in Standard/Dual SPI mode,
the QE bit is not cleared and the function of flash's WP# and RESET#/HOLD#
have been switched to IO2 and IO3 and are not restored.

Disable the Quad mode in spi_nor_restore(), then the flash's QE bit will
be cleared when removed. This will make sure the flash always enter the
Standard/Dual SPI mode when loaded.

Signed-off-by: Yicong Yang <yangyicong@hisilicon.com>
Reviewed-by: Pratyush Yadav <p.yadav@ti.com>
---
 drivers/mtd/spi-nor/core.c | 2 ++
 1 file changed, 2 insertions(+)
diff mbox series

Patch

diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
index f3d4b96..2099403 100644
--- a/drivers/mtd/spi-nor/core.c
+++ b/drivers/mtd/spi-nor/core.c
@@ -3000,6 +3000,8 @@  void spi_nor_restore(struct spi_nor *nor)
 	if (nor->addr_width == 4 && !(nor->flags & SNOR_F_4B_OPCODES) &&
 	    nor->flags & SNOR_F_BROKEN_RESET)
 		nor->params->set_4byte_addr_mode(nor, false);
+
+	spi_nor_quad_enable(nor, false);
 }
 EXPORT_SYMBOL_GPL(spi_nor_restore);