@@ -1052,20 +1052,11 @@ static void __maybe_unused omap_enable_hwecc_bch(struct mtd_info *mtd, int mode)
unsigned int dev_width, nsectors;
struct omap_nand_info *info = container_of(mtd, struct omap_nand_info,
mtd);
+ enum omap_ecc ecc_opt = info->ecc_opt;
struct nand_chip *chip = mtd->priv;
u32 val, wr_mode;
unsigned int ecc_size1, ecc_size0;
- /* Using wrapping mode 6 for writing */
- wr_mode = BCH_WRAPMODE_6;
-
- /*
- * ECC engine enabled for valid ecc_size0 nibbles
- * and disabled for ecc_size1 nibbles.
- */
- ecc_size0 = BCH_ECC_SIZE0;
- ecc_size1 = BCH_ECC_SIZE1;
-
/* Perform ecc calculation on 512-byte sector */
nsectors = 1;
@@ -1074,23 +1065,58 @@ static void __maybe_unused omap_enable_hwecc_bch(struct mtd_info *mtd, int mode)
/* Multi sector reading/writing for NAND flash with page size < 4096 */
if (info->is_elm_used && (mtd->writesize <= 4096)) {
- if (mode == NAND_ECC_READ) {
- /* Using wrapping mode 1 for reading */
- wr_mode = BCH_WRAPMODE_1;
-
- /*
- * ECC engine enabled for ecc_size0 nibbles
- * and disabled for ecc_size1 nibbles.
- */
- ecc_size0 = (nerrors == 8) ?
- BCH8R_ECC_SIZE0 : BCH4R_ECC_SIZE0;
- ecc_size1 = (nerrors == 8) ?
- BCH8R_ECC_SIZE1 : BCH4R_ECC_SIZE1;
- }
-
/* Perform ecc calculation for one page (< 4096) */
nsectors = info->nand.ecc.steps;
}
+ /* GPMC configurations for calculating ECC */
+ switch (ecc_opt) {
+ case OMAP_ECC_BCH4_CODE_HW_DETECTION_SW:
+ if (mode == NAND_ECC_READ) {
+ wr_mode = BCH_WRAPMODE_6;
+ ecc_size0 = BCH_ECC_SIZE0;
+ ecc_size1 = BCH_ECC_SIZE1;
+ } else {
+ wr_mode = BCH_WRAPMODE_6;
+ ecc_size0 = BCH_ECC_SIZE0;
+ ecc_size1 = BCH_ECC_SIZE1;
+ }
+ break;
+ case OMAP_ECC_BCH4_CODE_HW:
+ if (mode == NAND_ECC_READ) {
+ wr_mode = BCH_WRAPMODE_1;
+ ecc_size0 = BCH4R_ECC_SIZE0;
+ ecc_size1 = BCH4R_ECC_SIZE1;
+ } else {
+ wr_mode = BCH_WRAPMODE_6;
+ ecc_size0 = BCH_ECC_SIZE0;
+ ecc_size1 = BCH_ECC_SIZE1;
+ }
+ break;
+ case OMAP_ECC_BCH8_CODE_HW_DETECTION_SW:
+ if (mode == NAND_ECC_READ) {
+ wr_mode = BCH_WRAPMODE_6;
+ ecc_size0 = BCH_ECC_SIZE0;
+ ecc_size1 = BCH_ECC_SIZE1;
+ } else {
+ wr_mode = BCH_WRAPMODE_6;
+ ecc_size0 = BCH_ECC_SIZE0;
+ ecc_size1 = BCH_ECC_SIZE1;
+ }
+ break;
+ case OMAP_ECC_BCH8_CODE_HW:
+ if (mode == NAND_ECC_READ) {
+ wr_mode = BCH_WRAPMODE_1;
+ ecc_size0 = BCH8R_ECC_SIZE0;
+ ecc_size1 = BCH8R_ECC_SIZE1;
+ } else {
+ wr_mode = BCH_WRAPMODE_6;
+ ecc_size0 = BCH_ECC_SIZE0;
+ ecc_size1 = BCH_ECC_SIZE1;
+ }
+ break;
+ default:
+ return;
+ }
writel(ECC1, info->reg.gpmc_ecc_control);
Lots of if..then..else conditions in omap_enable_hwecc_bch() can be avoided if code is refactored based on ecc-scheme. Signed-off-by: Pekon Gupta <pekon@ti.com> --- drivers/mtd/nand/omap2.c | 74 ++++++++++++++++++++++++++++++++---------------- 1 file changed, 50 insertions(+), 24 deletions(-)