diff mbox series

[RFC,v8,net-next,04/16] net: mdio: mscc-miim: add ability to be used in a non-mmio configuration

Message ID 20220508185313.2222956-5-colin.foster@in-advantage.com
State New
Headers show
Series add support for VSC7512 control over SPI | expand

Commit Message

Colin Foster May 8, 2022, 6:53 p.m. UTC 
There are a few Ocelot chips that contain the logic for this bus, but are
controlled externally. Specifically the VSC7511, 7512, 7513, and 7514. In
the externally controlled configurations these registers are not
memory-mapped.

Add support for these non-memory-mapped configurations.

Signed-off-by: Colin Foster <colin.foster@in-advantage.com>
---
 drivers/net/mdio/mdio-mscc-miim.c | 31 +++++++++++++++++++++++--------
 1 file changed, 23 insertions(+), 8 deletions(-)

Comments

Andy Shevchenko May 8, 2022, 9:14 p.m. UTC | #1 
On Sun, May 8, 2022 at 8:53 PM Colin Foster
<colin.foster@in-advantage.com> wrote:
>
> There are a few Ocelot chips that contain the logic for this bus, but are
> controlled externally. Specifically the VSC7511, 7512, 7513, and 7514. In
> the externally controlled configurations these registers are not
> memory-mapped.
>
> Add support for these non-memory-mapped configurations.

...

> +               res = platform_get_resource(pdev, IORESOURCE_REG, 0);
> +               if (!res) {
> +                       dev_err(dev, "Unable to get MIIM resource\n");
> +                       return -ENODEV;

return dev_err_probe(...); ?

> +               }

...

> +       if (IS_ERR(phy_regmap)) {
> +               dev_err(dev, "Unable to create phy register regmap\n");
> +               return PTR_ERR(phy_regmap);

Ditto.

>         }
diff mbox series

Patch

diff --git a/drivers/net/mdio/mdio-mscc-miim.c b/drivers/net/mdio/mdio-mscc-miim.c
index 08541007b18a..728883f95edf 100644
--- a/drivers/net/mdio/mdio-mscc-miim.c
+++ b/drivers/net/mdio/mdio-mscc-miim.c
@@ -18,6 +18,7 @@ 
 #include <linux/platform_device.h>
 #include <linux/property.h>
 #include <linux/regmap.h>
+#include <soc/mscc/ocelot.h>
 
 #define MSCC_MIIM_REG_STATUS		0x0
 #define		MSCC_MIIM_STATUS_STAT_PENDING	BIT(2)
@@ -281,11 +282,20 @@  static int mscc_miim_probe(struct platform_device *pdev)
 
 	regs = devm_platform_get_and_ioremap_resource(pdev, 0, NULL);
 	if (IS_ERR(regs)) {
-		dev_err(dev, "Unable to map MIIM registers\n");
-		return PTR_ERR(regs);
-	}
+		/* Fall back to using IORESOURCE_REG, which is possible in an
+		 * MFD configuration
+		 */
+		res = platform_get_resource(pdev, IORESOURCE_REG, 0);
+		if (!res) {
+			dev_err(dev, "Unable to get MIIM resource\n");
+			return -ENODEV;
+		}
 
-	mii_regmap = devm_regmap_init_mmio(dev, regs, &mscc_miim_regmap_config);
+		mii_regmap = ocelot_init_regmap_from_resource(dev, res);
+	} else {
+		mii_regmap = devm_regmap_init_mmio(dev, regs,
+						   &mscc_miim_regmap_config);
+	}
 
 	if (IS_ERR(mii_regmap)) {
 		dev_err(dev, "Unable to create MIIM regmap\n");
@@ -303,10 +313,15 @@  static int mscc_miim_probe(struct platform_device *pdev)
 
 		phy_regmap = devm_regmap_init_mmio(dev, phy_regs,
 						   &mscc_miim_phy_regmap_config);
-		if (IS_ERR(phy_regmap)) {
-			dev_err(dev, "Unable to create phy register regmap\n");
-			return PTR_ERR(phy_regmap);
-		}
+	} else {
+		res = platform_get_resource(pdev, IORESOURCE_REG, 1);
+		if (res)
+			phy_regmap = ocelot_init_regmap_from_resource(dev, res);
+	}
+
+	if (IS_ERR(phy_regmap)) {
+		dev_err(dev, "Unable to create phy register regmap\n");
+		return PTR_ERR(phy_regmap);
 	}
 
 	ret = mscc_miim_setup(dev, &bus, "mscc_miim", mii_regmap, 0);