@@ -66,7 +66,7 @@ static int gpio_banks;
#define DEBOUNCE_VAL_SHIFT 17
#define DEBOUNCE_VAL (0x3fff << DEBOUNCE_VAL_SHIFT)
-/**
+/*
* These defines will translated the dt binding settings to our internal
* settings. They are not necessarily the same value as the register setting.
* The actual drive strength current of low, medium and high must be looked up
@@ -162,6 +162,10 @@ struct at91_pin_group {
* @set_pulldown: enable/disable pulldown
* @get_schmitt_trig: get schmitt trigger status
* @disable_schmitt_trig: disable schmitt trigger
+ * @get_drivestrength: get driver strength
+ * @set_drivestrength: set driver strength
+ * @get_slewrate: get slew rate
+ * @set_slewrate: set slew rate
* @irq_type: return irq type
*/
struct at91_pinctrl_mux_ops {
The documentation header for 'struct at91_pinctrl_mux_ops' was missing entries for {g,s}et_drivestrength and {g,s}et_slewrate. Fixes the following W=1 kernel build warning(s): drivers/pinctrl/pinctrl-at91.c:77: warning: cannot understand function prototype: 'enum drive_strength_bit ' drivers/pinctrl/pinctrl-at91.c:187: warning: Function parameter or member 'get_drivestrength' not described in 'at91_pinctrl_mux_ops' drivers/pinctrl/pinctrl-at91.c:187: warning: Function parameter or member 'set_drivestrength' not described in 'at91_pinctrl_mux_ops' drivers/pinctrl/pinctrl-at91.c:187: warning: Function parameter or member 'get_slewrate' not described in 'at91_pinctrl_mux_ops' drivers/pinctrl/pinctrl-at91.c:187: warning: Function parameter or member 'set_slewrate' not described in 'at91_pinctrl_mux_ops' Cc: Ludovic Desroches <ludovic.desroches@microchip.com> Cc: Nicolas Ferre <nicolas.ferre@microchip.com> Cc: Alexandre Belloni <alexandre.belloni@bootlin.com> Cc: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com> Signed-off-by: Lee Jones <lee.jones@linaro.org> --- drivers/pinctrl/pinctrl-at91.c | 6 +++++- 1 file changed, 5 insertions(+), 1 deletion(-)