| Message ID | 20190413165418.27880-10-megous@megous.com |
|---|---|
| State | New |
| Headers | show |
| Series | Add support for Orange Pi 3 | expand |
On Sat, Apr 13, 2019 at 06:54:18PM +0200, megous@megous.com wrote: > From: Ondrej Jirman <megous@megous.com> > > MMC1 is used on some H6 boards we want to support. Typical use is 4-bit > SDIO interface with a WiFi chip. Add pin definitions for this use case. > > As this is the only possible configration for mmc1, make it the default > one, too. > > Signed-off-by: Ondrej Jirman <megous@megous.com> Applied, thanks! Maxime -- Maxime Ripard, Bootlin Embedded Linux and Kernel engineering https://bootlin.com
diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi index e0dc4a05c1ba..bd37b849d3b7 100644 --- a/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi +++ b/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi @@ -243,6 +243,15 @@ bias-pull-up; }; + /omit-if-no-ref/ + mmc1_pins: mmc1-pins { + pins = "PG0", "PG1", "PG2", "PG3", + "PG4", "PG5"; + function = "mmc1"; + drive-strength = <30>; + bias-pull-up; + }; + mmc2_pins: mmc2-pins { pins = "PC1", "PC4", "PC5", "PC6", "PC7", "PC8", "PC9", "PC10", @@ -294,6 +303,8 @@ resets = <&ccu RST_BUS_MMC1>; reset-names = "ahb"; interrupts = <GIC_SPI 36 IRQ_TYPE_LEVEL_HIGH>; + pinctrl-names = "default"; + pinctrl-0 = <&mmc1_pins>; status = "disabled"; #address-cells = <1>; #size-cells = <0>;