diff mbox series

[v3,1/4] ext4: check and update i_disksize properly

Message ID 20210716122024.1105856-2-yi.zhang@huawei.com
State Accepted
Headers show
Series ext4: improve delalloc buffer write performance | expand

Commit Message

Zhang Yi July 16, 2021, 12:20 p.m. UTC 
After commit 3da40c7b0898 ("ext4: only call ext4_truncate when size <=
isize"), i_disksize could always be updated to i_size in ext4_setattr(),
and we could sure that i_disksize <= i_size since holding inode lock and
if i_disksize < i_size there are delalloc writes pending in the range
upto i_size. If the end of the current write is <= i_size, there's no
need to touch i_disksize since writeback will push i_disksize upto
i_size eventually. So we can switch to check i_size instead of
i_disksize in ext4_da_write_end() when write to the end of the file.
we also could remove ext4_mark_inode_dirty() together because we defer
inode dirtying to generic_write_end() or ext4_da_write_inline_data_end().

Signed-off-by: Zhang Yi <yi.zhang@huawei.com>
Reviewed-by: Jan Kara <jack@suse.cz>
---
 fs/ext4/inode.c | 34 ++++++++++++++++++----------------
 1 file changed, 18 insertions(+), 16 deletions(-)
diff mbox series

Patch

diff --git a/fs/ext4/inode.c b/fs/ext4/inode.c
index d8de607849df..dca8e3810443 100644
--- a/fs/ext4/inode.c
+++ b/fs/ext4/inode.c
@@ -3084,35 +3084,37 @@  static int ext4_da_write_end(struct file *file,
 	end = start + copied - 1;
 
 	/*
-	 * generic_write_end() will run mark_inode_dirty() if i_size
-	 * changes.  So let's piggyback the i_disksize mark_inode_dirty
-	 * into that.
+	 * Since we are holding inode lock, we are sure i_disksize <=
+	 * i_size. We also know that if i_disksize < i_size, there are
+	 * delalloc writes pending in the range upto i_size. If the end of
+	 * the current write is <= i_size, there's no need to touch
+	 * i_disksize since writeback will push i_disksize upto i_size
+	 * eventually. If the end of the current write is > i_size and
+	 * inside an allocated block (ext4_da_should_update_i_disksize()
+	 * check), we need to update i_disksize here as neither
+	 * ext4_writepage() nor certain ext4_writepages() paths not
+	 * allocating blocks update i_disksize.
+	 *
+	 * Note that we defer inode dirtying to generic_write_end() /
+	 * ext4_da_write_inline_data_end().
 	 */
 	new_i_size = pos + copied;
-	if (copied && new_i_size > EXT4_I(inode)->i_disksize) {
+	if (copied && new_i_size > inode->i_size) {
 		if (ext4_has_inline_data(inode) ||
-		    ext4_da_should_update_i_disksize(page, end)) {
+		    ext4_da_should_update_i_disksize(page, end))
 			ext4_update_i_disksize(inode, new_i_size);
-			/* We need to mark inode dirty even if
-			 * new_i_size is less that inode->i_size
-			 * bu greater than i_disksize.(hint delalloc)
-			 */
-			ret = ext4_mark_inode_dirty(handle, inode);
-		}
 	}
 
 	if (write_mode != CONVERT_INLINE_DATA &&
 	    ext4_test_inode_state(inode, EXT4_STATE_MAY_INLINE_DATA) &&
 	    ext4_has_inline_data(inode))
-		ret2 = ext4_da_write_inline_data_end(inode, pos, len, copied,
+		ret = ext4_da_write_inline_data_end(inode, pos, len, copied,
 						     page);
 	else
-		ret2 = generic_write_end(file, mapping, pos, len, copied,
+		ret = generic_write_end(file, mapping, pos, len, copied,
 							page, fsdata);
 
-	copied = ret2;
-	if (ret2 < 0)
-		ret = ret2;
+	copied = ret;
 	ret2 = ext4_journal_stop(handle);
 	if (unlikely(ret2 && !ret))
 		ret = ret2;