diff mbox series

[v4,1/2] dt-bindings: net: can: Document transceiver implementation as phy

Message ID 20210510052541.14168-2-a-govindraju@ti.com
State Not Applicable, archived
Headers show
Series MCAN: Add support for implementing transceiver as a phy | expand

Checks

Context Check Description
robh/checkpatch success
robh/dt-meta-schema success
robh/dtbs-check success

Commit Message

Aswath Govindraju May 10, 2021, 5:25 a.m. UTC 
From: Faiz Abbas <faiz_abbas@ti.com>

Some transceivers need a configuration step (for example, pulling the
standby or enable lines) for them to start sending messages. The
transceiver can be implemented as a phy with the configuration done in the
phy driver. The bit rate limitation can the be obtained by the driver using
the phy node.

Document the above implementation in the bosch mcan bindings

Signed-off-by: Faiz Abbas <faiz_abbas@ti.com>
Signed-off-by: Aswath Govindraju <a-govindraju@ti.com>
Acked-by: Rob Herring <robh@kernel.org>
---
 Documentation/devicetree/bindings/net/can/bosch,m_can.yaml | 3 +++
 1 file changed, 3 insertions(+)
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml b/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml
index 798fa5fb7bb2..25f74db46bae 100644
--- a/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml
+++ b/Documentation/devicetree/bindings/net/can/bosch,m_can.yaml
@@ -109,6 +109,9 @@  properties:
   can-transceiver:
     $ref: can-transceiver.yaml#
 
+  phys:
+    maxItems: 1
+
 required:
   - compatible
   - reg