@@ -342,10 +342,12 @@
#define H_CPU_CHAR_BRANCH_HINTS_HONORED (1ull << 58) // IBM bit 5
#define H_CPU_CHAR_THREAD_RECONFIG_CTRL (1ull << 57) // IBM bit 6
#define H_CPU_CHAR_COUNT_CACHE_DISABLED (1ull << 56) // IBM bit 7
+#define H_CPU_CHAR_BCCTR_FLUSH_ASSIST (1ull << 54) // IBM bit 9
#define H_CPU_BEHAV_FAVOUR_SECURITY (1ull << 63) // IBM bit 0
#define H_CPU_BEHAV_L1D_FLUSH_PR (1ull << 62) // IBM bit 1
#define H_CPU_BEHAV_BNDS_CHK_SPEC_BAR (1ull << 61) // IBM bit 2
+#define H_CPU_BEHAV_FLUSH_COUNT_CACHE (1ull << 58) // IBM bit 5
/* Flag values used in H_REGISTER_PROC_TBL hcall */
#define PROC_TABLE_OP_MASK 0x18
@@ -484,6 +484,12 @@ static void init_cpu_char_feature_flags(struct h_cpu_char_result *result)
if (result->character & H_CPU_CHAR_COUNT_CACHE_DISABLED)
security_ftr_set(SEC_FTR_COUNT_CACHE_DISABLED);
+ if (result->character & H_CPU_CHAR_BCCTR_FLUSH_ASSIST)
+ security_ftr_set(SEC_FTR_BCCTR_FLUSH_ASSIST);
+
+ if (result->behaviour & H_CPU_BEHAV_FLUSH_COUNT_CACHE)
+ security_ftr_set(SEC_FTR_FLUSH_COUNT_CACHE);
+
/*
* The features below are enabled by default, so we instead look to see
* if firmware has *disabled* them, and clear them if so.
@@ -535,6 +541,7 @@ void pseries_setup_rfi_flush(void)
setup_rfi_flush(types, enable);
setup_barrier_nospec();
+ setup_count_cache_flush();
}
#ifdef CONFIG_PCI_IOV
Use the existing hypercall to determine the appropriate settings for the count cache flush, and then call the generic powerpc code to set it up based on the security feature flags. Signed-off-by: Michael Ellerman <mpe@ellerman.id.au> --- arch/powerpc/include/asm/hvcall.h | 2 ++ arch/powerpc/platforms/pseries/setup.c | 7 +++++++ 2 files changed, 9 insertions(+)