@@ -109,12 +109,18 @@ static void __init tl_ap143_setup(void)
ath79_register_mdio(0, 0x0);
/* LAN */
+ ath79_eth1_data.phy_if_mode = PHY_INTERFACE_MODE_GMII;
+ ath79_eth1_data.duplex = DUPLEX_FULL;
+ ath79_switch_data.phy_poll_mask |= BIT(4);
ath79_init_mac(ath79_eth1_data.mac_addr, mac, 0);
ath79_register_eth(1);
/* WAN */
ath79_switch_data.phy4_mii_en = 1;
ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_MII;
+ ath79_eth0_data.duplex = DUPLEX_FULL;
+ ath79_eth0_data.speed = SPEED_100;
+ ath79_eth0_data.phy_mask = BIT(4);
ath79_init_mac(ath79_eth0_data.mac_addr, mac, 1);
ath79_register_eth(0);
@@ -105,12 +105,19 @@ static void __init common_setup(void)
ath79_register_mdio(0, 0x0);
/* LAN */
+ ath79_eth0_data.duplex = DUPLEX_FULL;
+ ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_MII;
+ ath79_eth0_data.speed = SPEED_100;
+ ath79_eth0_data.phy_mask = BIT(4);
ath79_init_mac(ath79_eth0_data.mac_addr, mac, 0);
ath79_register_eth(0);
/* WAN */
ath79_switch_data.phy4_mii_en = 1;
+ ath79_eth1_data.duplex = DUPLEX_FULL;
ath79_eth1_data.phy_if_mode = PHY_INTERFACE_MODE_MII;
+ ath79_eth1_data.speed = SPEED_100;
+ ath79_switch_data.phy_poll_mask |= BIT(4);
ath79_init_mac(ath79_eth1_data.mac_addr, mac, 1);
ath79_register_eth(1);
The initialization routines for these boards were relying on some (wrong) defaults for the QCA953x ethernet. Make these defaults explicit to prevent breaking them when the QCA953x defaults are fixed. Signed-off-by: Matthias Schiffer <mschiffer@universe-factory.net> Backport of r46206 --- target/linux/ar71xx/files/arch/mips/ath79/mach-tl-wr841n-v9.c | 6 ++++++ target/linux/ar71xx/files/arch/mips/ath79/mach-wpj531.c | 7 +++++++ 2 files changed, 13 insertions(+)