@@ -15,7 +15,7 @@
label-mac-device = &wifi;
};
- airrouter-leds {
+ leds {
compatible = "gpio-leds";
led_globe: globe {
@@ -78,30 +78,30 @@
read-only;
};
- partition@1 {
+ partition@40000 {
label = "u-boot-env";
reg = <0x040000 0x010000>;
};
- partition@2 {
+ partition@50000 {
compatible = "denx,uimage";
label = "firmware";
reg = <0x050000 0x750000>;
};
- partition@3 {
+ partition@7a0000 {
label = "board_config";
reg = <0x7a0000 0x010000>;
read-only;
};
- partition@4 {
+ partition@7b0000 {
label = "cfg";
reg = <0x7b0000 0x040000>;
read-only;
};
- art: partition@5 {
+ art: partition@7f0000 {
label = "art";
reg = <0x7f0000 0x010000>;
read-only;
@@ -9,12 +9,6 @@
compatible = "ubnt,xm", "qca,ar7241";
model = "Ubiquiti Networks XM (rev 1.0) board";
-/* extosc: ref {
- compatible = "fixed-clock";
- #clock-cells = <0>;
- clock-frequency = <40000000>;
- };
-*/
keys {
compatible = "gpio-keys";
@@ -30,12 +24,9 @@
status = "okay";
};
-/*&pll {
- clocks = <&extosc>;
-};*/
-
&spi {
status = "okay";
+
num-cs = <1>;
flash@0 {
@@ -54,30 +45,30 @@
read-only;
};
- partition@1 {
+ partition@40000 {
label = "u-boot-env";
reg = <0x040000 0x010000>;
};
- partition@2 {
+ partition@50000 {
compatible = "denx,uimage";
label = "firmware";
reg = <0x050000 0x750000>;
};
- partition@3 {
+ partition@7a0000 {
label = "board_config";
reg = <0x7a0000 0x010000>;
read-only;
};
- partition@4 {
+ partition@7b0000 {
label = "cfg";
reg = <0x7b0000 0x040000>;
read-only;
};
- art: partition@5 {
+ art: partition@7f0000 {
label = "art";
reg = <0x7f0000 0x010000>;
read-only;
@@ -11,6 +11,7 @@
leds {
compatible = "gpio-leds";
+
link1 {
label = "ubnt:red:link1";
gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
This applies minor style improvements and removes commented pll clock adjustments from ubnt_xm DTSI. The latter were introduced (already commented out) when adding ath79 target and have never been touched since then. For Unifi (BZ board), similar clock adjustments are employed and used. Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de> --- .../linux/ath79/dts/ar7241_ubnt_airrouter.dts | 2 +- target/linux/ath79/dts/ar7241_ubnt_unifi.dts | 10 ++++----- target/linux/ath79/dts/ar7241_ubnt_xm.dtsi | 21 ++++++------------- .../ath79/dts/ar7241_ubnt_xm_outdoor.dtsi | 1 + 4 files changed, 13 insertions(+), 21 deletions(-)