diff mbox series

[4/5] dt-bindings: mfd: da9062: add regulator gpio enable/disable documentation

Message ID 20190917124246.11732-5-m.felsch@pengutronix.de
State Changes Requested, archived
Headers show
Series DA9062 PMIC fixes and features | expand

Checks

Context Check Description
robh/checkpatch success

Commit Message

Marco Felsch Sept. 17, 2019, 12:42 p.m. UTC 
At the gpio-based regulator enable/disable documentation. This property
can be applied to each subnode within the 'regulators' node so each
regulator can be configured differently.

Signed-off-by: Marco Felsch <m.felsch@pengutronix.de>
---
 Documentation/devicetree/bindings/mfd/da9062.txt | 7 +++++++
 1 file changed, 7 insertions(+)
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/mfd/da9062.txt b/Documentation/devicetree/bindings/mfd/da9062.txt
index 9d9820d8177d..3d4b90bf8ea6 100644
--- a/Documentation/devicetree/bindings/mfd/da9062.txt
+++ b/Documentation/devicetree/bindings/mfd/da9062.txt
@@ -75,6 +75,13 @@  Sub-nodes:
     same. Also the gpio phandle must refer to to the dlg,da9062-gpio device
     other gpios are not allowed and make no sense.
 
+  - dlg,ena-sense-gpios : The GPIO reference which should be used by the
+    regulator to enable/disable the output. If the signal is active the
+    regulator is on else it is off. Attention: Sharing the same gpio for other
+    purposes or across multiple regulators is possible but the gpio settings
+    must be the same. Also the gpio phandle must refer to to the
+    dlg,da9062-gpio device other gpios are not allowed and make no sense.
+
 - rtc : This node defines settings required for the Real-Time Clock associated
   with the DA9062. There are currently no entries in this binding, however
   compatible = "dlg,da9062-rtc" should be added if a node is created.