diff mbox series

[U-Boot,2/3] configs: icorem6: Enable nandbcb command

Message ID 20190614073535.12502-2-shyam.saini@amarulasolutions.com
State Awaiting Upstream
Delegated to: Stefano Babic
Headers show
Series [U-Boot,v6,1/3] i.MX6: nand: add nandbcb command for imx | expand

Commit Message

Shyam Saini June 14, 2019, 7:35 a.m. UTC 
This also enables mtd configs which are required by nandbcb command.

This command would be used to configure boot control block(BCB) while
writing spl image on nand device.

Signed-off-by: Shyam Saini <shyam.saini@amarulasolutions.com>
---
 configs/imx6qdl_icore_mmc_defconfig | 4 ++++
 1 file changed, 4 insertions(+)
diff mbox series

Patch

diff --git a/configs/imx6qdl_icore_mmc_defconfig b/configs/imx6qdl_icore_mmc_defconfig
index b65979967a..620d49f954 100644
--- a/configs/imx6qdl_icore_mmc_defconfig
+++ b/configs/imx6qdl_icore_mmc_defconfig
@@ -15,6 +15,7 @@  CONFIG_DEBUG_UART_BASE=0x021f0000
 CONFIG_DEBUG_UART_CLOCK=24000000
 CONFIG_SPL_LIBDISK_SUPPORT=y
 # CONFIG_CMD_BMODE is not set
+CONFIG_CMD_NANDBCB=y
 CONFIG_DEBUG_UART=y
 CONFIG_FIT=y
 CONFIG_FIT_SIGNATURE=y
@@ -58,6 +59,9 @@  CONFIG_SYS_I2C_MXC=y
 CONFIG_FSL_ESDHC=y
 CONFIG_NAND=y
 CONFIG_NAND_MXS=y
+CONFIG_CMD_MTDPARTS=y
+CONFIG_MTDIDS_DEFAULT="nand0=gpmi-nand"
+CONFIG_MTDPARTS_DEFAULT="mtdparts=gpmi-nand:2m(spl),2m(uboot),1m(env),8m(kernel),1m(dtb),-(rootfs)"
 CONFIG_PHYLIB=y
 CONFIG_PHY_SMSC=y
 CONFIG_FEC_MXC=y