@@ -781,7 +781,7 @@ static int esdhc_set_voltage(struct mmc *mmc)
case MMC_SIGNAL_VOLTAGE_330:
if (priv->vs18_enable)
return -EIO;
-#ifdef CONFIG_DM_REGULATOR
+#if CONFIG_IS_ENABLED(DM_REGULATOR)
if (!IS_ERR_OR_NULL(priv->vqmmc_dev)) {
ret = regulator_set_value(priv->vqmmc_dev, 3300000);
if (ret) {
@@ -800,7 +800,7 @@ static int esdhc_set_voltage(struct mmc *mmc)
return -EAGAIN;
case MMC_SIGNAL_VOLTAGE_180:
-#ifdef CONFIG_DM_REGULATOR
+#if CONFIG_IS_ENABLED(DM_REGULATOR)
if (!IS_ERR_OR_NULL(priv->vqmmc_dev)) {
ret = regulator_set_value(priv->vqmmc_dev, 1800000);
if (ret) {
@@ -1401,7 +1401,7 @@ static int fsl_esdhc_probe(struct udevice *dev)
int node = dev_of_offset(dev);
struct esdhc_soc_data *data =
(struct esdhc_soc_data *)dev_get_driver_data(dev);
-#ifdef CONFIG_DM_REGULATOR
+#if CONFIG_IS_ENABLED(DM_REGULATOR)
struct udevice *vqmmc_dev;
#endif
fdt_addr_t addr;
@@ -1459,7 +1459,7 @@ static int fsl_esdhc_probe(struct udevice *dev)
priv->vs18_enable = 0;
-#ifdef CONFIG_DM_REGULATOR
+#if CONFIG_IS_ENABLED(DM_REGULATOR)
/*
* If emmc I/O has a fixed voltage at 1.8V, this must be provided,
* otherwise, emmc will work abnormally.
Since the fsl_esdhc will also be used by SPL, make the preprocessor switches more generic to allow any kind of build. Signed-off-by: Abel Vesa <abel.vesa@nxp.com> --- drivers/mmc/fsl_esdhc.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)