Message ID | 1383770684.3741.28.camel@localhost |
---|---|
State | Changes Requested |
Delegated to: | Stefano Babic |
Headers | show |
Hi Giuseppe, On 06/11/2013 21:44, Giuseppe Pagano wrote: > To have watchdog quiet during kernel boot it is necessary to > change gpio wdt trigger direction. > Sorry, this is not a good explanation. You force a GPIO to drop a feture, instead of disabling the feature itself. And maybe some other people want to have this feature enabled. Which is the timeout for the watchdog ? Why is it hitting too soon ? Fix should be not done simply removing the effect, but checking the cause. > > Signed-off-by: Giuseppe Pagano <giuseppe.pagano@seco.com> > Cc: sbabic@denx.de > > --- > > diff -uNr a/board/udoo/udoo.c b/board/udoo/udoo.c > --- a/board/udoo/udoo.c 2013-11-06 18:47:26.000000000 +0100 > +++ b/board/udoo/udoo.c 2013-11-06 18:54:46.000000000 +0100 > @@ -168,6 +168,7 @@ > imx_iomux_v3_setup_multiple_pads(wdog_pads, > ARRAY_SIZE(wdog_pads)); > gpio_direction_output(WDT_TRG, 0); > gpio_direction_output(WDT_EN, 1); > + gpio_direction_input(WDT_TRG); I do not think this a right way to disable a watchdog. Best regards, Stefano Babic
Hi Stefano, On Thu, 2013-11-07 at 09:19 +0100, Stefano Babic wrote: > Hi Giuseppe, > > On 06/11/2013 21:44, Giuseppe Pagano wrote: > > To have watchdog quiet during kernel boot it is necessary to > > change gpio wdt trigger direction. > > > > Sorry, this is not a good explanation. You force a GPIO to drop a > feture, instead of disabling the feature itself. And maybe some other > people want to have this feature enabled. > > Which is the timeout for the watchdog ? Why is it hitting too soon ? > > Fix should be not done simply removing the effect, but checking the cause. I know, my explanation was poor. uDoo use APX823-31W5 as watchdog chip. Timeout is about 1.2 seconds. To disabled watchdog during kernel boot, WDI pin of that chip needs to be in "high impedance" state. As far as I known mx6 gpio configuration does not contemplate tristate, so the option I choose is to set pin as input and in "high impedance". If wdt gpio is leaved as output che chip resets. > > Best regards, > Stefano Babic > Best regards, Giuseppe Pagano
diff -uNr a/board/udoo/udoo.c b/board/udoo/udoo.c --- a/board/udoo/udoo.c 2013-11-06 18:47:26.000000000 +0100 +++ b/board/udoo/udoo.c 2013-11-06 18:54:46.000000000 +0100 @@ -168,6 +168,7 @@ imx_iomux_v3_setup_multiple_pads(wdog_pads, ARRAY_SIZE(wdog_pads)); gpio_direction_output(WDT_TRG, 0); gpio_direction_output(WDT_EN, 1); + gpio_direction_input(WDT_TRG); }
To have watchdog quiet during kernel boot it is necessary to change gpio wdt trigger direction. Signed-off-by: Giuseppe Pagano <giuseppe.pagano@seco.com> Cc: sbabic@denx.de --- static struct fsl_esdhc_cfg usdhc_cfg = { USDHC3_BASE_ADDR };