| Message ID | 20240328153415.3706637-4-lukma@denx.de |
|---|---|
| State | Changes Requested |
| Delegated to: | Fabio Estevam |
| Headers | show |
| Series | arm: xea: Provide enhancements for XEA board | expand |
diff --git a/board/liebherr/xea/spl_xea.c b/board/liebherr/xea/spl_xea.c index 71194db235..6cf8f8390e 100644 --- a/board/liebherr/xea/spl_xea.c +++ b/board/liebherr/xea/spl_xea.c @@ -225,7 +225,8 @@ const iomux_cfg_t iomux_setup[] = { MX28_PAD_ENET0_TXD0__ENET0_TXD0 | MUX_CONFIG_ENET, MX28_PAD_ENET0_TXD1__ENET0_TXD1 | MUX_CONFIG_ENET, MX28_PAD_ENET0_TXD3__ENET1_TXD1 | MUX_CONFIG_ENET, - MX28_PAD_SSP1_CMD__GPIO_2_13, /* PHY reset */ + MX28_PAD_SSP1_CMD__GPIO_2_13, /* PHY reset HW Rev. 1*/ + MX28_PAD_SAIF0_LRCLK__GPIO_3_21, /* PHY reset HW Rev. 2*/ /* TIVA boot control */ MX28_PAD_GPMI_RDY3__GPIO_0_23 | MUX_CONFIG_BOOT, /* TIVA0 */
The imx287 based XEA board's revision 2 uses GPIO_3_21 for PHY reset It is safe to keep the GPIO_2_13 as well, as in the SPL SPI1 is not used for transmission. This simplifies the code, as the proper configuration is performed either in falcon boot's read DTB or in u-boot proper (with correct FIT configuration chosen). Signed-off-by: Lukasz Majewski <lukma@denx.de> --- board/liebherr/xea/spl_xea.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)