@@ -152,6 +152,7 @@ config TARGET_OCTEONTX2_CN913x
config TARGET_DB_MV784MP_GP
bool "Support db-mv784mp-gp"
+ select BOARD_ECC_SUPPORT
select MV78460
config TARGET_DS414
@@ -160,6 +161,7 @@ config TARGET_DS414
config TARGET_MAXBCM
bool "Support maxbcm"
+ select BOARD_ECC_SUPPORT
select MV78460
config TARGET_THEADORABLE
@@ -226,6 +228,9 @@ config DDR_RESET_ON_TRAINING_FAILURE
device will still hang - it doesn't make sense to reset the board
in such a case.
+config BOARD_ECC_SUPPORT
+ bool
+
config SYS_BOARD
default "clearfog" if TARGET_CLEARFOG
default "helios4" if TARGET_HELIOS4
@@ -72,6 +72,5 @@
/* Enable DDR support in SPL (DDR3 training from Marvell bin_hdr) */
#define CONFIG_SPD_EEPROM 0x4e
-#define CONFIG_BOARD_ECC_SUPPORT /* this board supports ECC */
#endif /* _CONFIG_DB_MV7846MP_GP_H */
@@ -64,6 +64,5 @@
/* Enable DDR support in SPL (DDR3 training from Marvell bin_hdr) */
#define CONFIG_SYS_SDRAM_SIZE SZ_1G
-#define CONFIG_BOARD_ECC_SUPPORT /* this board supports ECC */
#endif /* _CONFIG_DB_MV7846MP_GP_H */
This converts the following to Kconfig: CONFIG_BOARD_ECC_SUPPORT Signed-off-by: Tom Rini <trini@konsulko.com> --- arch/arm/mach-mvebu/Kconfig | 5 +++++ include/configs/db-mv784mp-gp.h | 1 - include/configs/maxbcm.h | 1 - 3 files changed, 5 insertions(+), 2 deletions(-)