diff mbox series

[PATCHv2,20/25] arm: mach-k3: do board config for PM and RM only if supported

Message ID 20201120112326.10350-21-t-kristo@ti.com
State New
Delegated to: Lokesh Vutla
Headers show
Series J72xx: HSM rearch support series | expand

Commit Message

Tero Kristo Nov. 20, 2020, 11:23 a.m. UTC
If the raw PM support is built in, we are operating in the split
firmware approach mode where RM and PM support is not available. In this
case, skip the board config for these two.

Signed-off-by: Tero Kristo <t-kristo@ti.com>
 arch/arm/mach-k3/sysfw-loader.c | 4 ++++
 1 file changed, 4 insertions(+)
diff mbox series


diff --git a/arch/arm/mach-k3/sysfw-loader.c b/arch/arm/mach-k3/sysfw-loader.c
index 78c158c63f..e753f629ff 100644
--- a/arch/arm/mach-k3/sysfw-loader.c
+++ b/arch/arm/mach-k3/sysfw-loader.c
@@ -158,11 +158,13 @@  static void k3_sysfw_configure_using_fit(void *fit,
 	/* Apply power/clock (PM) specific configuration to SYSFW */
+#ifndef CONFIG_K3_DM_FW
 	ret = board_ops->board_config_pm(ti_sci,
 	if (ret)
 		panic("Failed to set board PM configuration (%d)\n", ret);
 	/* Extract resource management (RM) specific configuration from FIT */
 	ret = fit_get_data_by_name(fit, images, SYSFW_CFG_RM,
@@ -171,12 +173,14 @@  static void k3_sysfw_configure_using_fit(void *fit,
 		panic("Error accessing %s node in FIT (%d)\n", SYSFW_CFG_RM,
+#ifndef CONFIG_K3_DM_FW
 	/* Apply resource management (RM) configuration to SYSFW */
 	ret = board_ops->board_config_rm(ti_sci,
 	if (ret)
 		panic("Failed to set board RM configuration (%d)\n", ret);
 	/* Extract security specific configuration from FIT */
 	ret = fit_get_data_by_name(fit, images, SYSFW_CFG_SEC,