| Message ID | 1310470007-6213-1-git-send-email-sr@denx.de |
|---|---|
| State | Accepted |
| Commit | 3ce04d9bba017012751cbecf25b923bcb02ccb54 |
| Delegated to: | Stefan Roese |
| Headers | show |
On Tuesday 12 July 2011 13:26:47 Stefan Roese wrote: > Only install der 4xx-EMAC interrupt handlers *after* the core > network driver is registered. > > This problem was noticed on the APM Taishan 440GX board, where > the board hung upon bootup after displaying "Net:". Applied to u-boot-ppc4xx. Thanks, Stefan -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office@denx.de
diff --git a/drivers/net/4xx_enet.c b/drivers/net/4xx_enet.c index b1763b1..f328574 100644 --- a/drivers/net/4xx_enet.c +++ b/drivers/net/4xx_enet.c @@ -2035,6 +2035,13 @@ int ppc_4xx_eth_initialize (bd_t * bis) dev->send = ppc_4xx_eth_send; dev->recv = ppc_4xx_eth_rx; + eth_register(dev); + +#if defined(CONFIG_MII) || defined(CONFIG_CMD_MII) + miiphy_register(dev->name, + emac4xx_miiphy_read, emac4xx_miiphy_write); +#endif + if (0 == virgin) { /* set the MAL IER ??? names may change with new spec ??? */ #if defined(CONFIG_440SPE) || \ @@ -2072,13 +2079,6 @@ int ppc_4xx_eth_initialize (bd_t * bis) dev); virgin = 1; } - - eth_register (dev); - -#if defined(CONFIG_MII) || defined(CONFIG_CMD_MII) - miiphy_register (dev->name, - emac4xx_miiphy_read, emac4xx_miiphy_write); -#endif } /* end for each supported device */ return 0;
Only install der 4xx-EMAC interrupt handlers *after* the core network driver is registered. This problem was noticed on the APM Taishan 440GX board, where the board hung upon bootup after displaying "Net:". Signed-off-by: Stefan Roese <sr@denx.de> --- drivers/net/4xx_enet.c | 14 +++++++------- 1 files changed, 7 insertions(+), 7 deletions(-)