Series |
Add and update drivers for MediaTek MT76x8 SoCs
|
expand
-
[U-Boot,v2,00/28] Add and update drivers for MediaTek MT76x8 SoCs
-
[U-Boot,v2,01/28] serial: serial_mtk: enable FIFO and disable flow control
-
[U-Boot,v2,02/28] serial: serial_mtk: add non-DM version for SPL
-
[U-Boot,v2,03/28] dts: mtmips: move uart property clock-frequency into mt7628an.dtsi
-
[U-Boot,v2,04/28] dts: mtmips: enable high-speed UART support for mt7628
-
[U-Boot,v2,05/28] clk: add clock driver for MediaTek MT76x8 platform
-
[U-Boot,v2,06/28] dts: mtmips: add clock node for mt7628
-
[U-Boot,v2,07/28] spi: mt7621-spi: use clock frequency from clk driver
-
[U-Boot,v2,08/28] spi: mt7621-spi: remove data cache and rewrite its xfer function
-
[U-Boot,v2,09/28] spi: mt7621-spi: restore default register value after each xfer
-
[U-Boot,v2,10/28] pinctrl: add support for MediaTek MT7628
-
[U-Boot,v2,11/28] dts: mtmips: add pinctrl node for mt7628
-
[U-Boot,v2,12/28] dts: mtmips: add default pinctrl for uart nodes
-
[U-Boot,v2,13/28] reset: add reset controller driver for MediaTek MIPS platform
-
[U-Boot,v2,14/28] dts: mtmips: update reset controller node for mt7628
-
[U-Boot,v2,15/28] phy: mt76x8-usb-phy: add slew rate calibration and remove non-mt7628 part
-
[U-Boot,v2,16/28] net: mt7628-eth: remove hardcoded gpio settings and regmap-based phy reset
-
[U-Boot,v2,17/28] net: mt7628-eth: make phy link up detection optional via DT
-
[U-Boot,v2,18/28] net: mt7628-eth: free rx descriptor on receiving failure
-
[U-Boot,v2,19/28] net: mt7628-eth: add support to isolate LAN/WAN ports
-
[U-Boot,v2,20/28] dts: mtmips: enable eth port0 led and link poll functions for all boards
-
[U-Boot,v2,21/28] mmc: mtk-sd: add support for MediaTek MT7620/MT7628 SoCs
-
[U-Boot,v2,22/28] mmc: mtk-sd: add a dts property cd-active-high for builtin-cd mode
-
[U-Boot,v2,23/28] dts: mtmips: add mmc related nodes for mt7628an.dtsi
-
[U-Boot,v2,24/28] dts: mtmips: add default pinctrl for gardena-smart-gateway-mt7688
-
[U-Boot,v2,25/28] dts: mtmips: add default pinctrl to eth nodes for all boards
-
[U-Boot,v2,26/28] mips: mtmips: change baudrate table for all boards
-
[U-Boot,v2,27/28] mips: mtmips: select essential drivers in Kconfig
-
[U-Boot,v2,28/28] configs: mtmips: remove configs which are selected in Kconfig or useless
|