@@ -122,6 +122,9 @@ enum ds_type {
#define RX8130_REG_FLAG_AF BIT(3)
#define RX8130_REG_CONTROL0 0x1e
#define RX8130_REG_CONTROL0_AIE BIT(3)
+#define RX8130_REG_CONTROL1 0x1f
+#define RX8130_REG_CONTROL1_INIEN BIT(4)
+#define RX8130_REG_CONTROL1_CHGEN BIT(5)
#define MCP794XX_REG_CONTROL 0x07
# define MCP794XX_BIT_ALM0_EN 0x10
@@ -536,6 +539,16 @@ static u8 do_trickle_setup_ds1339(struct ds1307 *ds1307, u32 ohms, bool diode)
return setup;
}
+static u8 do_trickle_setup_rx8130(struct ds1307 *ds1307, u32 ohms, bool diode)
+{
+ /* make sure that the backup battery is enabled */
+ u8 setup = RX8130_REG_CONTROL1_INIEN;
+ if (diode)
+ setup |= RX8130_REG_CONTROL1_CHGEN;
+
+ return setup;
+}
+
static irqreturn_t rx8130_irq(int irq, void *dev_id)
{
struct ds1307 *ds1307 = dev_id;
@@ -1024,6 +1037,8 @@ static const struct chip_desc chips[last_ds_type] = {
.offset = 0x10,
.irq_handler = rx8130_irq,
.rtc_ops = &rx8130_rtc_ops,
+ .trickle_charger_reg = RX8130_REG_CONTROL1,
+ .do_trickle_setup = &do_trickle_setup_rx8130,
},
[m41t0] = {
.rtc_ops = &m41txx_rtc_ops,
The ds1307 charger infrastructure now allows to add a rx8130 charger setup that.. - does not depend on trickle-resistor-ohms - does not use DS13XX_TRICKLE_CHARGER_MAGIC trickle-charge select (TCS) bits - keeps previous no-charge behavior for device trees without aux-voltage-chargeable Make that happen. Signed-off-by: Bastian Krause <bst@pengutronix.de> --- No changes since v1. v1 notes: Based on: - https://lore.kernel.org/linux-rtc/20200415163701.21989-1-bst@pengutronix.de/ - https://lore.kernel.org/linux-rtc/20200415163701.21989-3-bst@pengutronix.de/ Changes since then: - use chager_reg (called trickle_charger_reg before patch 4/8) - use charger setup function to set backup battery enable bit, charge bit optionally (introduced by patch 5/8) --- drivers/rtc/rtc-ds1307.c | 15 +++++++++++++++ 1 file changed, 15 insertions(+)