diff mbox series

[PULL,48/49] docs/system/arm/mps2.rst: Document the new mps3-an524 board

Message ID 20210305171515.1038-49-peter.maydell@linaro.org
State New
Headers show
Series [PULL,01/49] sbsa-ref: remove cortex-a53 from list of supported cpus | expand

Commit Message

Peter Maydell March 5, 2021, 5:15 p.m. UTC
Add brief documentation of the new mps3-an524 board.

Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <f4bug@amsat.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20210215115138.20465-24-peter.maydell@linaro.org
---
 docs/system/arm/mps2.rst | 24 ++++++++++++++++++------
 1 file changed, 18 insertions(+), 6 deletions(-)
diff mbox series

Patch

diff --git a/docs/system/arm/mps2.rst b/docs/system/arm/mps2.rst
index 8c5b5f1fe07..601ccea15cb 100644
--- a/docs/system/arm/mps2.rst
+++ b/docs/system/arm/mps2.rst
@@ -1,12 +1,15 @@ 
-Arm MPS2 boards (``mps2-an385``, ``mps2-an386``, ``mps2-an500``, ``mps2-an505``, ``mps2-an511``, ``mps2-an521``)
-================================================================================================================
+Arm MPS2 and MPS3 boards (``mps2-an385``, ``mps2-an386``, ``mps2-an500``, ``mps2-an505``, ``mps2-an511``, ``mps2-an521``, ``mps3-an524``)
+=========================================================================================================================================
 
 These board models all use Arm M-profile CPUs.
 
-The Arm MPS2 and MPS2+ dev boards are FPGA based (the 2+ has a bigger
-FPGA but is otherwise the same as the 2). Since the CPU itself
-and most of the devices are in the FPGA, the details of the board
-as seen by the guest depend significantly on the FPGA image.
+The Arm MPS2, MPS2+ and MPS3 dev boards are FPGA based (the 2+ has a
+bigger FPGA but is otherwise the same as the 2; the 3 has a bigger
+FPGA again, can handle 4GB of RAM and has a USB controller and QSPI flash).
+
+Since the CPU itself and most of the devices are in the FPGA, the
+details of the board as seen by the guest depend significantly on the
+FPGA image.
 
 QEMU models the following FPGA images:
 
@@ -22,12 +25,21 @@  QEMU models the following FPGA images:
   Cortex-M3 'DesignStart' as documented in Arm Application Note AN511
 ``mps2-an521``
   Dual Cortex-M33 as documented in Arm Application Note AN521
+``mps3-an524``
+  Dual Cortex-M33 on an MPS3, as documented in Arm Application Note AN524
 
 Differences between QEMU and real hardware:
 
 - AN385/AN386 remapping of low 16K of memory to either ZBT SSRAM1 or to
   block RAM is unimplemented (QEMU always maps this to ZBT SSRAM1, as
   if zbt_boot_ctrl is always zero)
+- AN524 remapping of low memory to either BRAM or to QSPI flash is
+  unimplemented (QEMU always maps this to BRAM, ignoring the
+  SCC CFG_REG0 memory-remap bit)
 - QEMU provides a LAN9118 ethernet rather than LAN9220; the only guest
   visible difference is that the LAN9118 doesn't support checksum
   offloading
+- QEMU does not model the QSPI flash in MPS3 boards as real QSPI
+  flash, but only as simple ROM, so attempting to rewrite the flash
+  from the guest will fail
+- QEMU does not model the USB controller in MPS3 boards