@@ -881,6 +881,11 @@ static void usbredir_device_connect(void *priv,
{
USBRedirDevice *dev = priv;
+ if (qemu_timer_pending(dev->attach_timer) || dev->dev.attached) {
+ ERROR("Received device connect while already connected\n");
+ return;
+ }
+
switch (device_connect->speed) {
case usb_redir_speed_low:
DPRINTF("attaching low speed device\n");
@@ -909,19 +914,26 @@ static void usbredir_device_connect(void *priv,
static void usbredir_device_disconnect(void *priv)
{
USBRedirDevice *dev = priv;
+ int i;
/* Stop any pending attaches */
qemu_del_timer(dev->attach_timer);
if (dev->dev.attached) {
usb_device_detach(&dev->dev);
- usbredir_cleanup_device_queues(dev);
/*
* Delay next usb device attach to give the guest a chance to see
* see the detach / attach in case of quick close / open succession
*/
dev->next_attach_time = qemu_get_clock_ms(vm_clock) + 200;
}
+
+ /* Reset state so that the next dev connected starts with a clean slate */
+ usbredir_cleanup_device_queues(dev);
+ memset(dev->endpoint, 0, sizeof(dev->endpoint));
+ for (i = 0; i < MAX_ENDPOINTS; i++) {
+ QTAILQ_INIT(&dev->endpoint[i].bufpq);
+ }
}
static void usbredir_interface_info(void *priv,
@@ -1013,6 +1025,10 @@ static void usbredir_iso_stream_status(void *priv, uint32_t id,
DPRINTF("iso status %d ep %02X id %u\n", iso_stream_status->status,
ep, id);
+ if (!dev->dev.attached) {
+ return;
+ }
+
dev->endpoint[EP2I(ep)].iso_error = iso_stream_status->status;
if (iso_stream_status->status == usb_redir_stall) {
DPRINTF("iso stream stopped by peer ep %02X\n", ep);
@@ -1030,6 +1046,10 @@ static void usbredir_interrupt_receiving_status(void *priv, uint32_t id,
DPRINTF("interrupt recv status %d ep %02X id %u\n",
interrupt_receiving_status->status, ep, id);
+ if (!dev->dev.attached) {
+ return;
+ }
+
dev->endpoint[EP2I(ep)].interrupt_error =
interrupt_receiving_status->status;
if (interrupt_receiving_status->status == usb_redir_stall) {
These fixes mainly target the other side sending some (error status) packets after a disconnect packet. In some cases these would get queued up and then reported to the controller when a new device gets connected. * Fully reset device state on disconnect * Don't allow a connect message when already connected * Ignore iso and interrupt status messages when disconnected Signed-off-by: Hans de Goede <hdegoede@redhat.com> --- usb-redir.c | 22 +++++++++++++++++++++- 1 files changed, 21 insertions(+), 1 deletions(-)