diff mbox

ide/core: Remove explicit setting of BM_STATUS_INT

Message ID 1305817571-21430-1-git-send-email-kwolf@redhat.com
State New
Headers show

Commit Message

Kevin Wolf May 19, 2011, 3:06 p.m. UTC 
BM_STATUS_INT is automatically set during ide_set_irq(), there's no reason to
set it manually in addition.

There is even one case where the interrupt status bit was set, but no IRQ was
raised. This is when the PRD table was reached but there is more data to
transfer. The correct behaviour for this case is not to set BM_STATUS_INT.

Signed-off-by: Kevin Wolf <kwolf@redhat.com>
---
 hw/ide/core.c |    7 ++++---
 1 files changed, 4 insertions(+), 3 deletions(-)
diff mbox

Patch

diff --git a/hw/ide/core.c b/hw/ide/core.c
index 45410e8..95beb17 100644
--- a/hw/ide/core.c
+++ b/hw/ide/core.c
@@ -430,7 +430,6 @@  void ide_dma_error(IDEState *s)
     s->error = ABRT_ERR;
     s->status = READY_STAT | ERR_STAT;
     ide_set_inactive(s);
-    s->bus->dma->ops->add_status(s->bus->dma, BM_STATUS_INT);
     ide_set_irq(s->bus);
 }
 
@@ -500,8 +499,11 @@  handle_rw_error:
     n = s->nsector;
     s->io_buffer_index = 0;
     s->io_buffer_size = n * 512;
-    if (s->bus->dma->ops->prepare_buf(s->bus->dma, s->is_read) == 0)
+    if (s->bus->dma->ops->prepare_buf(s->bus->dma, s->is_read) == 0) {
+        /* The PRDs were too short. Reset the Active bit, but don't raise an
+         * interrupt. */
         goto eot;
+    }
 
 #ifdef DEBUG_AIO
     printf("ide_dma_cb: sector_num=%" PRId64 " n=%d, is_read=%d\n",
@@ -523,7 +525,6 @@  handle_rw_error:
     return;
 
 eot:
-   s->bus->dma->ops->add_status(s->bus->dma, BM_STATUS_INT);
    ide_set_inactive(s);
 }