@@ -45,6 +45,14 @@ case "$board" in
ucidef_set_led_switch "lan3" "LAN3" "$boardname:green:lan3" "switch0" "0x08"
ucidef_set_led_switch "lan4" "LAN4" "$boardname:green:lan4" "switch0" "0x10"
;;
+"tplink,tl-wr741nd-v4"|\
+"tplink,tl-wr740nd-v4")
+ ucidef_set_led_netdev "wan" "WAN" "tp-link:green:wan" "eth1"
+ ucidef_set_led_switch "lan1" "LAN1" "tp-link:green:lan1" "switch0" "0x04"
+ ucidef_set_led_switch "lan2" "LAN2" "tp-link:green:lan2" "switch0" "0x08"
+ ucidef_set_led_switch "lan3" "LAN3" "tp-link:green:lan3" "switch0" "0x10"
+ ucidef_set_led_switch "lan4" "LAN4" "tp-link:green:lan4" "switch0" "0x02"
+ ;;
esac
board_config_flush
@@ -62,6 +62,13 @@ ath79_setup_interfaces()
"0@eth1" "1:lan" "2:lan" "3:lan" "4:lan"
;;
+ "tplink,tl-wr741nd-v4"|\
+ "tplink,tl-wr740nd-v4")
+ ucidef_set_interfaces_wan "eth1"
+ ucidef_add_switch "switch0" \
+ "0@eth0" "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1"
+ ;;
+
"tplink,tl-wr1043nd-v1")
ucidef_add_switch "switch0" \
"1:lan" "2:lan" "3:lan" "4:lan" "0:wan" "5@eth0"
new file mode 100644
@@ -0,0 +1,9 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "ar9331_tl-wr741nd-v4.dtsi"
+
+/ {
+ model = "TP-Link TL-WR740N/ND v4";
+ compatible = "tplink,tl-wr740n-v4";
+};
new file mode 100644
@@ -0,0 +1,9 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "ar9331_tl-wr741nd-v4.dtsi"
+
+/ {
+ model = "TP-Link TL-WR741N/ND v4";
+ compatible = "tplink,tl-wr741n-v4";
+};
new file mode 100644
@@ -0,0 +1,173 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "ar9331.dtsi"
+
+/ {
+ compatible = "tplink,tl-wr741n-v4", "qca,ar9331";
+ model = "TP-Link TL-WR741N/ND v4";
+
+ aliases {
+ serial0 = &uart;
+ led-status = &led_system;
+ };
+
+ gpio-keys-polled {
+ compatible = "gpio-keys-polled";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ poll-interval = <20>;
+
+ reset {
+ label = "reset";
+ linux,code = <KEY_RESTART>;
+ gpios = <&gpio 11 GPIO_ACTIVE_HIGH>;
+ debounce-interval = <60>;
+ };
+
+ wps {
+ label = "wps";
+ linux,code = <KEY_WPS_BUTTON>;
+ gpios = <&gpio 26 GPIO_ACTIVE_HIGH>;
+ debounce-interval = <60>;
+ };
+ };
+
+ gpio-leds {
+ compatible = "gpio-leds";
+ pinctrl-names = "default";
+ pinctrl-0 = <&switch_led_pins>;
+
+ lan1 {
+ label = "tp-link:green:lan1";
+ gpios = <&gpio 14 GPIO_ACTIVE_HIGH>;
+ };
+
+ lan2 {
+ label = "tp-link:green:lan2";
+ gpios = <&gpio 15 GPIO_ACTIVE_HIGH>;
+ };
+
+ lan3 {
+ label = "tp-link:green:lan3";
+ gpios = <&gpio 16 GPIO_ACTIVE_HIGH>;
+ };
+
+ lan4 {
+ label = "tp-link:green:lan4";
+ gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
+ };
+
+ qss {
+ label = "tp-link:green:qss";
+ gpios = <&gpio 1 GPIO_ACTIVE_HIGH>;
+ };
+
+ led_system: system {
+ label = "tp-link:green:system";
+ gpios = <&gpio 27 GPIO_ACTIVE_HIGH>;
+ };
+
+ wan {
+ label = "tp-link:green:wan";
+ gpios = <&gpio 13 GPIO_ACTIVE_HIGH>;
+ };
+
+ wlan {
+ label = "tp-link:green:wlan";
+ gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
+ default-state = "off";
+ linux,default-trigger = "phy0tpt";
+ };
+ };
+};
+
+&spi {
+ status = "okay";
+ num-cs = <1>;
+
+ flash@0 {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <25000000>;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ uboot: partition@0 {
+ reg = <0x0 0x20000>;
+ label = "u-boot";
+ read-only;
+ };
+
+ firmware: partition@20000 {
+ reg = <0x20000 0x3d0000>;
+ label = "firmware";
+ };
+
+ art: partition@3f0000 {
+ reg = <0x3f0000 0x10000>;
+ label = "art";
+ read-only;
+ };
+ };
+ };
+};
+
+&mdio0 {
+ status = "okay";
+
+ phy4: ethernet-phy@4 {
+ reg = <4>;
+ phy-mode = "mii";
+ };
+};
+
+ð0 {
+ status = "okay";
+
+ phy-handle = <&phy4>;
+
+ mtd-mac-address = <&uboot 0x1fc00>;
+ mtd-mac-address-increment = <1>;
+
+ gmac-config {
+ device = <&gmac>;
+
+ switch-phy-addr-swap = <1>;
+ switch-phy-swap = <1>;
+ };
+};
+
+ð1 {
+ status = "okay";
+
+ mtd-mac-address = <&uboot 0x1fc00>;
+ mtd-mac-address-increment = <(-1)>;
+
+ fixed-link {
+ speed = <1000>;
+ full-duplex;
+ };
+};
+
+&gpio {
+ status = "okay";
+};
+
+&uart {
+ status = "okay";
+};
+
+&wmac {
+ status = "okay";
+ mtd-cal-data = <&art 0x1000>;
+ mtd-mac-address = <&uboot 0x1fc00>;
+};
@@ -39,3 +39,21 @@ define Device/tl-wr740n-v2
SUPPORTED_DEVICES := tplink,tl-wr740n-v2 tl-wr740n-v2
endef
TARGET_DEVICES += tl-wr740n-v2
+
+define Device/tl-wr741nd-v4
+ $(Device/tplink-4mlzma)
+ ATH_SOC := ar9331
+ DEVICE_TITLE := TP-LINK TL-WR741N/ND v4
+ TPLINK_HWID := 0x07410004
+ SUPPORTED_DEVICES := tplink,tl-wr741n-v4 tl-wr741n-v4
+endef
+TARGET_DEVICES += tl-wr741nd-v4
+
+define Device/tl-wr740nd-v4
+ $(Device/tplink-4mlzma)
+ ATH_SOC := ar9331
+ DEVICE_TITLE := TP-LINK TL-WR740N/ND v4
+ TPLINK_HWID := 0x07400004
+ SUPPORTED_DEVICES := tplink,tl-wr740n-v4 tl-wr740n-v4
+endef
+TARGET_DEVICES += tl-wr740nd-v4
This patch ports the TP-Link TL-WR741ND v4 and TL-WR740ND v4 to the ath79 target. Because the two devices share the same hw layout, this patch adds a common .dtsi which is included by the two .dts. Signed-off-by: Rocco Folino <rocco@folino.io> --- .../ath79/base-files/etc/board.d/01_leds | 8 + .../ath79/base-files/etc/board.d/02_network | 7 + .../linux/ath79/dts/ar9331_tl-wr740nd-v4.dts | 9 + .../linux/ath79/dts/ar9331_tl-wr741nd-v4.dts | 9 + .../linux/ath79/dts/ar9331_tl-wr741nd-v4.dtsi | 173 ++++++++++++++++++ target/linux/ath79/image/tiny-tp-link.mk | 18 ++ 6 files changed, 224 insertions(+) create mode 100644 target/linux/ath79/dts/ar9331_tl-wr740nd-v4.dts create mode 100644 target/linux/ath79/dts/ar9331_tl-wr741nd-v4.dts create mode 100644 target/linux/ath79/dts/ar9331_tl-wr741nd-v4.dtsi