@@ -29,6 +29,7 @@
wlan2g {
label = "hc5661:blue:wlan2g";
gpios = <&gpio3 0 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "phy0tpt";
};
};
};
@@ -29,11 +29,13 @@
wlan2g {
label = "hc5761:blue:wlan2g";
gpios = <&gpio3 0 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "phy1tpt";
};
wlan5g {
label = "hc5761:blue:wlan5g";
gpios = <&gpio0 7 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "phy0tpt";
};
};
};
@@ -24,6 +24,7 @@
wlan2g {
label = "hc5861:blue:wlan2g";
gpios = <&gpio0 11 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "phy1tpt";
};
internet {
@@ -34,6 +35,7 @@
wlan5g {
label = "hc5861:blue:wlan5g";
gpios = <&gpio0 7 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "phy0tpt";
};
turbo {
@@ -111,19 +111,12 @@ glinet,gl-mt300n|\
glinet,gl-mt750)
set_wifi_led "$boardname:wlan"
;;
-hiwifi,hc5661)
- ucidef_set_led_switch "internet" "internet" "$boardname:blue:internet" "switch0" "0x01"
- set_wifi_led "$boardname:blue:wlan2g"
- ;;
+hiwifi,hc5661|\
hiwifi,hc5761)
ucidef_set_led_switch "internet" "internet" "$boardname:blue:internet" "switch0" "0x01"
- ucidef_set_led_netdev "wifi5g" "wifi5g" "$boardname:blue:wlan5g" "wlan0"
- ucidef_set_led_netdev "wifi2g" "wifi2g" "$boardname:blue:wlan2g" "wlan1"
;;
hiwifi,hc5861)
ucidef_set_led_switch "internet" "internet" "$boardname:blue:internet" "switch0" "0x20"
- ucidef_set_led_netdev "wifi5g" "wifi5g" "$boardname:blue:wlan5g" "wlan0"
- ucidef_set_led_netdev "wifi2g" "wifi2g" "$boardname:blue:wlan2g" "wlan1"
;;
hnet,c108)
ucidef_set_led_netdev "lan" "lan" "$boardname:green:lan" "eth0"
Throughput trigger support for MT7620 has been added, so switch to it Signed-off-by: DENG Qingfang <dengqf6@mail2.sysu.edu.cn> --- Change since v1: Split out non-existent LED removal part Tested on HC5761 --- target/linux/ramips/dts/mt7620a_hiwifi_hc5661.dts | 1 + target/linux/ramips/dts/mt7620a_hiwifi_hc5761.dts | 2 ++ target/linux/ramips/dts/mt7620a_hiwifi_hc5861.dts | 2 ++ .../linux/ramips/mt7620/base-files/etc/board.d/01_leds | 9 +-------- 4 files changed, 6 insertions(+), 8 deletions(-)