| Message ID | 20151029144601.GA28537@makrotopia.org |
|---|---|
| State | Accepted |
| Headers | show |
diff --git a/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips b/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips index 90b6d15..3dce1b6 100644 --- a/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips +++ b/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips @@ -23,8 +23,8 @@ ramips_set_preinit_iface() { swconfig dev rt305x vlan 1 set ports "0 6" swconfig dev rt305x port 6 set untag 0 swconfig dev rt305x set apply 1 - vconfig add eth0 1 - ifconfig eth0 up + ip link add link eth0 name eth0.1 type vlan id 1 + ip link set eth0 up ifname=eth0.1 else ifname=eth0
Replace use of vconfig with the corresponding iproute2 syntax in /lib/preinit/07_set_preinit_iface_ramips The switch reset work-around needed on some ramips targets used the deprecated vconfig tool to bring up the pre-init/failsafe interface. This doesn't work on recent builds where vconfig is no longer being deployed, resulting in the device being unreachable when triggered into failsafe mode. Signed-off-by: Daniel Golle <daniel@makrotopia.org> --- .../linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)