@@ -263,8 +263,6 @@ setup_fou_or_gue() {
${ns_a} ip link set ${encap}_a up
${ns_b} ip link set ${encap}_b up
-
- sleep 1
}
setup_fou44() {
@@ -302,6 +300,10 @@ setup_gue66() {
setup_namespaces() {
for n in ${NS_A} ${NS_B} ${NS_R1} ${NS_R2}; do
ip netns add ${n} || return 1
+
+ # Disable DAD, so that we don't have to wait to use the
+ # configured IPv6 addresses
+ ip netns exec ${n} sysctl -q net/ipv6/conf/default/accept_dad=0
done
}
@@ -337,8 +339,6 @@ setup_vti() {
${ns_a} ip link set vti${proto}_a up
${ns_b} ip link set vti${proto}_b up
-
- sleep 1
}
setup_vti4() {
@@ -375,8 +375,6 @@ setup_vxlan_or_geneve() {
${ns_a} ip link set ${type}_a up
${ns_b} ip link set ${type}_b up
-
- sleep 1
}
setup_geneve4() {
@@ -588,8 +586,8 @@ test_pmtu_ipvX() {
mtu "${ns_b}" veth_B-R2 1500
# Create route exceptions
- ${ns_a} ${ping} -q -M want -i 0.1 -w 2 -s 1800 ${dst1} > /dev/null
- ${ns_a} ${ping} -q -M want -i 0.1 -w 2 -s 1800 ${dst2} > /dev/null
+ ${ns_a} ${ping} -q -M want -i 0.1 -w 1 -s 1800 ${dst1} > /dev/null
+ ${ns_a} ${ping} -q -M want -i 0.1 -w 1 -s 1800 ${dst2} > /dev/null
# Check that exceptions have been created with the correct PMTU
pmtu_1="$(route_get_dst_pmtu_from_exception "${ns_a}" ${dst1})"
@@ -621,7 +619,7 @@ test_pmtu_ipvX() {
# Decrease remote MTU on path via R2, get new exception
mtu "${ns_r2}" veth_R2-B 400
mtu "${ns_b}" veth_B-R2 400
- ${ns_a} ${ping} -q -M want -i 0.1 -w 2 -s 1400 ${dst2} > /dev/null
+ ${ns_a} ${ping} -q -M want -i 0.1 -w 1 -s 1400 ${dst2} > /dev/null
pmtu_2="$(route_get_dst_pmtu_from_exception "${ns_a}" ${dst2})"
check_pmtu_value "lock 552" "${pmtu_2}" "exceeding MTU, with MTU < min_pmtu" || return 1
@@ -638,7 +636,7 @@ test_pmtu_ipvX() {
check_pmtu_value "1500" "${pmtu_2}" "increasing local MTU" || return 1
# Get new exception
- ${ns_a} ${ping} -q -M want -i 0.1 -w 2 -s 1400 ${dst2} > /dev/null
+ ${ns_a} ${ping} -q -M want -i 0.1 -w 1 -s 1400 ${dst2} > /dev/null
pmtu_2="$(route_get_dst_pmtu_from_exception "${ns_a}" ${dst2})"
check_pmtu_value "lock 552" "${pmtu_2}" "exceeding MTU, with MTU < min_pmtu" || return 1
}
@@ -687,7 +685,7 @@ test_pmtu_ipvX_over_vxlanY_or_geneveY_exception() {
mtu "${ns_a}" ${type}_a $((${ll_mtu} + 1000))
mtu "${ns_b}" ${type}_b $((${ll_mtu} + 1000))
- ${ns_a} ${ping} -q -M want -i 0.1 -w 2 -s $((${ll_mtu} + 500)) ${dst} > /dev/null
+ ${ns_a} ${ping} -q -M want -i 0.1 -w 1 -s $((${ll_mtu} + 500)) ${dst} > /dev/null
# Check that exception was created
pmtu="$(route_get_dst_pmtu_from_exception "${ns_a}" ${dst})"
@@ -767,7 +765,7 @@ test_pmtu_ipvX_over_fouY_or_gueY() {
mtu "${ns_a}" ${encap}_a $((${ll_mtu} + 1000))
mtu "${ns_b}" ${encap}_b $((${ll_mtu} + 1000))
- ${ns_a} ${ping} -q -M want -i 0.1 -w 2 -s $((${ll_mtu} + 500)) ${dst} > /dev/null
+ ${ns_a} ${ping} -q -M want -i 0.1 -w 1 -s $((${ll_mtu} + 500)) ${dst} > /dev/null
# Check that exception was created
pmtu="$(route_get_dst_pmtu_from_exception "${ns_a}" ${dst})"
@@ -825,13 +823,13 @@ test_pmtu_vti4_exception() {
# Send DF packet without exceeding link layer MTU, check that no
# exception is created
- ${ns_a} ping -q -M want -i 0.1 -w 2 -s ${ping_payload} ${tunnel4_b_addr} > /dev/null
+ ${ns_a} ping -q -M want -i 0.1 -w 1 -s ${ping_payload} ${tunnel4_b_addr} > /dev/null
pmtu="$(route_get_dst_pmtu_from_exception "${ns_a}" ${tunnel4_b_addr})"
check_pmtu_value "" "${pmtu}" "sending packet smaller than PMTU (IP payload length ${esp_payload_rfc4106})" || return 1
# Now exceed link layer MTU by one byte, check that exception is created
# with the right PMTU value
- ${ns_a} ping -q -M want -i 0.1 -w 2 -s $((ping_payload + 1)) ${tunnel4_b_addr} > /dev/null
+ ${ns_a} ping -q -M want -i 0.1 -w 1 -s $((ping_payload + 1)) ${tunnel4_b_addr} > /dev/null
pmtu="$(route_get_dst_pmtu_from_exception "${ns_a}" ${tunnel4_b_addr})"
check_pmtu_value "${esp_payload_rfc4106}" "${pmtu}" "exceeding PMTU (IP payload length $((esp_payload_rfc4106 + 1)))"
}
@@ -847,7 +845,7 @@ test_pmtu_vti6_exception() {
mtu "${ns_b}" veth_b 4000
mtu "${ns_a}" vti6_a 5000
mtu "${ns_b}" vti6_b 5000
- ${ns_a} ${ping6} -q -i 0.1 -w 2 -s 60000 ${tunnel6_b_addr} > /dev/null
+ ${ns_a} ${ping6} -q -i 0.1 -w 1 -s 60000 ${tunnel6_b_addr} > /dev/null
# Check that exception was created
pmtu="$(route_get_dst_pmtu_from_exception "${ns_a}" ${tunnel6_b_addr})"
Otherwise, the configured IPv6 address could be still "tentative" at test time, possibly causing tests failures. We can also drop some sleep along the code and decrease the timeout for most commands so that the test runtime decreases. v1 -> v2: - fix comment (Stefano) Fixes: d1f1b9cbf34c ("selftests: net: Introduce first PMTU test") Signed-off-by: Paolo Abeni <pabeni@redhat.com> Reviewed-by: David Ahern <dsahern@gmail.com> --- tools/testing/selftests/net/pmtu.sh | 28 +++++++++++++--------------- 1 file changed, 13 insertions(+), 15 deletions(-)