@@ -225,54 +225,6 @@ mv88e6060_phy_write(struct dsa_switch *ds, int port, int regnum, u16 val)
return reg_write(ds, addr, regnum, val);
}
-static void mv88e6060_poll_link(struct dsa_switch *ds)
-{
- int i;
-
- for (i = 0; i < DSA_MAX_PORTS; i++) {
- struct net_device *dev;
- int uninitialized_var(port_status);
- int link;
- int speed;
- int duplex;
- int fc;
-
- dev = ds->ports[i];
- if (dev == NULL)
- continue;
-
- link = 0;
- if (dev->flags & IFF_UP) {
- port_status = reg_read(ds, REG_PORT(i), 0x00);
- if (port_status < 0)
- continue;
-
- link = !!(port_status & 0x1000);
- }
-
- if (!link) {
- if (netif_carrier_ok(dev)) {
- netdev_info(dev, "link down\n");
- netif_carrier_off(dev);
- }
- continue;
- }
-
- speed = (port_status & 0x0100) ? 100 : 10;
- duplex = (port_status & 0x0200) ? 1 : 0;
- fc = ((port_status & 0xc000) == 0xc000) ? 1 : 0;
-
- if (!netif_carrier_ok(dev)) {
- netdev_info(dev,
- "link up, %d Mb/s, %s duplex, flow control %sabled\n",
- speed,
- duplex ? "full" : "half",
- fc ? "en" : "dis");
- netif_carrier_on(dev);
- }
- }
-}
-
static struct dsa_switch_driver mv88e6060_switch_driver = {
.tag_protocol = DSA_TAG_PROTO_TRAILER,
.probe = mv88e6060_probe,
@@ -280,7 +232,6 @@ static struct dsa_switch_driver mv88e6060_switch_driver = {
.set_addr = mv88e6060_set_addr,
.phy_read = mv88e6060_phy_read,
.phy_write = mv88e6060_phy_write,
- .poll_link = mv88e6060_poll_link,
};
static int __init mv88e6060_init(void)
As of mv88e6xxx remove the poll_link callback since the link state change polling is now handled by the phylib. Tested on a mv88e6060 B0 device with a TI DM816X SoC. Suggested-by: Andrew Lunn <andrew@lunn.ch> Signed-off-by: Neil Armstrong <narmstrong@baylibre.com> --- drivers/net/dsa/mv88e6060.c | 49 --------------------------------------------- 1 file changed, 49 deletions(-)