Message ID | 392fb48f0906120616n123d8b57h9ef7c8e1735d26bf@mail.gmail.com |
---|---|
State | Rejected, archived |
Delegated to: | David Miller |
Headers | show |
On Fri, 12 Jun 2009 22:16:42 +0900 Mike McCormack <mikem@ring3k.org> wrote: > 2009/6/12 Stephen Hemminger <shemminger@linux-foundation.org> > > > Does the following fix the problem? > > I tried your patch out, but it still got a crash. > > The patch below does fix the problem. Does this look better? > > thanks, > > Mike > > ----------------------------- > > Subject: [PATCH] sky2: Shutdown receive path cleanly in sky2_down > > If sky2_down was called while receiving a packet, receive interrupts > would still occur after the receive buffer was free'd causing a crash in > sky2_status_intr. > > To avoid further receive interrupts after sky2_down: > > * make sure NAPI and interrupts are fully disabled during shutdown > * call sky2_rx_stop after shutting down the receiver > * clear received packets after shutdown > > Signed-off-by: Mike McCormack <mikem@ring3k.org> > --- > drivers/net/sky2.c | 21 +++++++++++++++------ > 1 files changed, 15 insertions(+), 6 deletions(-) > > diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c > index a2ff9cb..136b362 100644 > --- a/drivers/net/sky2.c > +++ b/drivers/net/sky2.c > @@ -1805,10 +1805,13 @@ static int sky2_down(struct net_device *dev) > /* Disable port IRQ */ > imask = sky2_read32(hw, B0_IMSK); > imask &= ~portirq_msk[port]; > - sky2_write32(hw, B0_IMSK, imask); > + sky2_write32(hw, B0_IMSK, 0); > This breaks on 2 port boards. On dual port boards, both ports share the same IRQ.
diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c index a2ff9cb..136b362 100644 --- a/drivers/net/sky2.c +++ b/drivers/net/sky2.c @@ -1805,10 +1805,13 @@ static int sky2_down(struct net_device *dev) /* Disable port IRQ */ imask = sky2_read32(hw, B0_IMSK); imask &= ~portirq_msk[port]; - sky2_write32(hw, B0_IMSK, imask); + sky2_write32(hw, B0_IMSK, 0); synchronize_irq(hw->pdev->irq); + /* disable soft interrupts */ + napi_disable(&hw->napi); + sky2_gmac_reset(hw, port); /* Stop transmitter */ @@ -1822,9 +1825,6 @@ static int sky2_down(struct net_device *dev) ctrl &= ~(GM_GPCR_TX_ENA | GM_GPCR_RX_ENA); gma_write16(hw, port, GM_GP_CTRL, ctrl); - /* Make sure no packets are pending */ - napi_synchronize(&hw->napi); - sky2_write8(hw, SK_REG(port, GPHY_CTRL), GPC_RST_SET); /* Workaround shared GMAC reset */ @@ -1850,11 +1850,11 @@ static int sky2_down(struct net_device *dev) sky2_write32(hw, RB_ADDR(txqaddr[port], RB_CTRL), RB_RST_SET); - sky2_rx_stop(sky2); - sky2_write8(hw, SK_REG(port, RX_GMF_CTRL_T), GMF_RST_SET); sky2_write8(hw, SK_REG(port, TX_GMF_CTRL_T), GMF_RST_SET); + sky2_rx_stop(sky2); + sky2_phy_power_down(hw, port); /* turn off LED's */ @@ -1878,6 +1878,15 @@ static int sky2_down(struct net_device *dev) sky2->rx_ring = NULL; sky2->tx_ring = NULL; + /* clear receive interrupt condition and IRQ */ + hw->st_idx = sky2_read16(hw, STAT_PUT_IDX); + + /* re-enable interrupts */ + sky2_write32(hw, B0_IMSK, imask); + + /* re-enable soft interrupts */ + napi_enable(&hw->napi); + return 0; }